Honda-SOHC
SOHC.co.uk Forums => CB500/550 => Topic started by: Seabeowner on February 26, 2024, 05:07:19 PM
-
Looking for criticism and sources for paint.
I have an old tank that I have de-rusted and filled a few small dents. It is not really worth spending money on a professional finish as it will be another spare. I have sprayed a few bikes, but that was 40 years ago! And fifty years ago I bought a new 500 (my avatar) in candy garnet brown, so that is the colour for this one.
1. Spray with etch primer because that’s what our factory sprayer did first when I was working. Do I need this?
2. Spray with epoxy primer. Final light rub down.
3. Base coat. What do I need?
4. Spray candy garnet brown all over. How much paint do I need. 500ml seems enough.
5. Cure.
6. Mask for black panels at side of tank.
7. Spray black.
8. Cure.
9. Apply striping decals.
10. Spray 2K lacquer. I know it’s nasty stuff.
Intend to use aerosol rattle cans for steps 1, 2, and 10.
Will also do a test piece as I progress to check paint compatibility.
This has been on here before, but looking for sources and recommendations for paint. I only remember RS paint.
Thanks for any info/advice.
-
Just done the tank for Lazarus in black using spray cans, your method seems ok but I might put at least one layer of lacquer before stripes to even the transition between colours and stripe.
-
I would use German made SprayMax 2k gloss rattle can for the clear coat. Expensive but lovely spray pattern and superb finish if you are careful. I always wear my air fed mask with it. Some people use a Gersen disposable mask with it.
-
Thanks for the info Mick and Ash.
Any other sources for the candy paint?
And what about basecoat. Nothing on RS site. I could give them a ring.
-
Well according to RS paints their garnet brown does not require a base coat.
Other sources say UC-16-100 which seems to be cloud silver.
Am considering this on top of their silver.
https://www.ebay.co.uk/itm/284052756978
-
Decided on a close candy match (or maybe not) to the brown.
But haven't yet got the paint for the black sides.
Any suggestions appreciated for quality black aerosols for this?
Will use the SprayMax lacquer on top.
-
Decided on a close candy match (or maybe not) to the brown.
But haven't yet got the paint for the black sides.
Any suggestions appreciated for quality black aerosols for this?
Will use the SprayMax lacquer on top.
Honda NH1 is the black.
-
I presume you mean 500mL un-thinned as it normally comes from a apint supplier,(thins 50/50%) ... If so yes plenty enough.
For black panel:-
https://www.paints4u.com/Customer/ProductDetails/Index/12003
[attachimg=1]