736
CB750 / K7 F1 engine parts on a K0
« on: November 30, 2009, 10:01:59 PM »
Hi everyone,
I tried to get a reply to this one on the US site but surprisingly no response.
My 750 K0 was purchased with 40 odd K miles on the clock and had not been used for about 17 years so I never heard the engine running. I have a heap of new or low miles parts for it including crank, barrels and pistons and new genuine chains etc. The original top end I am sure has been replaced as it is in very good condition and there are seals on both inlet and exhaust valve guides.
Here is the question - I have quite a few parts from a K7 and F1 engine and these include complete clutch (with the double 'B' plate), shifter forks and shift drum. Since these parts were upgraded on the later bikes (as detailed in Honda Service Bulletins for better transmission shifting etc.), is it worth me using them instead of the original K0 parts? Obviously I would retain the originals for historical reasons. Also are there any other 'upgraded' parts I should look at using from the later engine?
I tried to get a reply to this one on the US site but surprisingly no response.
My 750 K0 was purchased with 40 odd K miles on the clock and had not been used for about 17 years so I never heard the engine running. I have a heap of new or low miles parts for it including crank, barrels and pistons and new genuine chains etc. The original top end I am sure has been replaced as it is in very good condition and there are seals on both inlet and exhaust valve guides.
Here is the question - I have quite a few parts from a K7 and F1 engine and these include complete clutch (with the double 'B' plate), shifter forks and shift drum. Since these parts were upgraded on the later bikes (as detailed in Honda Service Bulletins for better transmission shifting etc.), is it worth me using them instead of the original K0 parts? Obviously I would retain the originals for historical reasons. Also are there any other 'upgraded' parts I should look at using from the later engine?