Honda-SOHC

Hi, I've got carpys 4 into 1 nicely made I have had it ceramic coated but he now does it in stainless pretty cheap considering it didn't cost much for shipping etc it's a bit loud but I like it loud !!! Link below

www.cb750cafe.com/products-page/exhaust

There's also this place very good to deal with

http://www.cyclexchange.net/Exhaust%20System%20Page.htm

David Silver do standard spoke kits not sure if there stainless though I bought mine from DS and had them individually powder coated by Central Wheels,  cheers

Hi Guys,

I did my engine without taking apart all I took off to paint individually was the breather cover on top of the engine and the sprocket cover,

I Gunked my engine to get the worst of the grime off which worked very well
 

After that I gave it a good clean to remove the gunk residue then got to work with my Dremmel I ordered various dremmel bits but found the small wire brushes the best to get in between the fins in all it took me over a week just to prepare the engine for painting,

I made sure the engine was spotless before painting for paint I used Simonez paint spray which doesn't need primer or baking I masked off the finned part splines etc  then did the silver first I gave it 4 coats with at least a day in between, this is how it turned out,

 

Hi Folks I was wondering is there a specific measurement for the gap between the slider when it bottoms out in the body of the carb ?? I found this pic on a website but there is no measurement stated ??

Cheers Stu.

Hi billy I asked the same question a wee while back you've got 3 yellow wires and one white it probably looks yellowish it doesn't matter which yellow goes to which the white wire is the female connector pictured,

Cheers

Stuart

Cheers guys I've taken the PC off to bare metal and secured with a new nut and bolt !!!

Cheers

Refrence the negitive cable to engine

Can I ground it to anywhere on the frame ??

Cheers

I've also put the needle clip to the middle slot
Cheers