This section allows you to view all posts made by this member. Note that you can only see posts made in areas you currently have access to.
Messages - Bryanj
Pages: 1 ... 662 663 [664] 665 666 ... 672
9946
« on: November 21, 2008, 10:05:40 AM »
Only cos i crawled in from work at 07:00 and tripped over my ID book!
9947
« on: November 21, 2008, 06:59:13 AM »
I think Pirahna and Newtronic are the same thing--better is Dyna or gp to the US site and look up "hondaman" he makes an electronic system triggered by the points run at a very low current so they last forever(nearly)
9948
« on: November 21, 2008, 06:56:08 AM »
Dont shout too loud, having talked to Dave the answer is at least Honda still make em---complain too much about quality and instead of improving they have a tendency to obsolete
9949
« on: November 21, 2008, 06:53:34 AM »
400 never came with alloys standard and if frame number starts with a 1 its a 75 model
9950
« on: November 20, 2008, 05:46:43 PM »
The two inners have different ID bores and the bigger one should be a tap fit same as the race you took off
9951
« on: November 20, 2008, 06:44:55 AM »
Sorry Mike but gotta say no cos washers is flat and that is shaped mate
9952
« on: November 18, 2008, 05:00:37 PM »
Try it without the washer from the kit first, I seem to remember washer went on some models but not others.
as long as bearings adjust nice with no free play all is OK
9953
« on: November 18, 2008, 03:02:12 PM »
Memory vague but seem to remember it was either the honda washer or the kit washer not both
9954
« on: November 10, 2008, 06:25:54 PM »
More likely to be the pirahna playing up than the coil mate, have you got the bits to re-convert to points?
9955
« on: November 10, 2008, 12:08:13 PM »
Thts the idea but use a "soft" drift and to get them all the way in use the old race as a spacer cos you can still get that out afterwards
9956
« on: November 10, 2008, 05:30:24 AM »
The "inners" have different ID small to top big to bottom, washer goes onto steering stem before lower inner. Make sure you get the "outers" in right as once they are in up to the shoulder you cant get them out short of destruction
9957
« on: November 07, 2008, 05:19:00 PM »
Silkolene Transfleet 10w40 is exactly in the Honda spec if you can get it
9958
« on: November 07, 2008, 03:49:16 AM »
Not worth the cost as you still have to change it every 1500 miles
9959
« on: November 06, 2008, 12:05:41 PM »
Sorry to hear youre bad news mate, give me a ring if you want advise on wheel building, its not difficult just takes time and patience and there are ways to make it easier.
9960
« on: November 04, 2008, 07:19:37 AM »
Now come on, i told youz b4 my 'puter is dyslexic!
Pages: 1 ... 662 663 [664] 665 666 ... 672
|
Show Posts