1
SOHC Singles & Twins / Re: Cb/cd 175 kickstart circlip?
« Last post by Arch stanton on Today at 02:00:18 PM »Hello Ian.
Thank you for your experience. I was working along similar lines.
One of my many regrets is not learning how to use a Lathe & milling machine. I presume you had to turn in id to fit over the domed shaft end. With the od sufficient to drive the clip into its seat. I ordered what was listed as the correct part. But the clip does appear to be a tad small.
Regards
Sean.
Thank you for your experience. I was working along similar lines.
One of my many regrets is not learning how to use a Lathe & milling machine. I presume you had to turn in id to fit over the domed shaft end. With the od sufficient to drive the clip into its seat. I ordered what was listed as the correct part. But the clip does appear to be a tad small.
Regards
Sean.