Honda-SOHC

SOHC.co.uk Forums => CB750 => Topic started by: FATAL on October 22, 2007, 06:20:33 PM

Title: Taper roller bearings
Post by: FATAL on October 22, 2007, 06:20:33 PM: I finally got around to fitting taper roller steering head bearings to my F1, but the steering stop lugs are a bit too low to engage with the stop on the head. ??? I assume this is because of the large thick washer that is fitted at the bottom of the stem, and then the rubber dust seal. The original bottom washer is very thin, and I'm thinking that if I refit a standard size (thin) washer instead of the very thick one then all should be tickety boo.

Has anyone had similar problems when fitting these bearing kits?

P.S. this restoration project seems to be taking forever!
Title: Re: Taper roller bearings
Post by: Spitfire on October 22, 2007, 06:50:54 PM: Hi Fatal,
Where did you get the kit from, I got mine from David Silver Spares and it fitted no problem, used the thick washer on the bottom yoke, have you drifted the bottom race right up into the steering stem ? I had to clear a layer of powder coating from mine before fitting it.

Cheers

Den
(http://i192.photobucket.com/albums/z244/DennisMcc/Progress%20shots/SteeringheadbearingsFeb006.jpg)
(http://i192.photobucket.com/albums/z244/DennisMcc/Progress%20shots/SteeringheadbearingsFeb003.jpg)
(http://i192.photobucket.com/albums/z244/DennisMcc/Progress%20shots/SteeringheadbearingsFeb001.jpg)
(http://i192.photobucket.com/albums/z244/DennisMcc/Progress%20shots/Steeringheadbearings004.jpg)
Title: Re: Taper roller bearings
Post by: FATAL on October 23, 2007, 08:21:27 PM: Thanks Den, I got the bearings from Wemoto. Looking at your photos It seems as if I haven't quite got the bearing down far enough, your rubber seal appears to be more compressed, but the washer on yours looks the same. I think perhaps there was a little overspray of paint at the bottom of the stem. I'll take the bearing off and double check everything. I'll probably need to reorder a bearing as it looks a right tw*t to get off!
Title: Re: Taper roller bearings
Post by: FATAL on October 28, 2007, 01:52:33 PM: D'ohhh I've just had another look, I've not set the bearing cup far enough in the stem ;D, (been suffering from a virul infection so not been thinking straight) all sorted now. I must pay more attention :-[
Title: Re: Taper roller bearings
Post by: Spitfire on October 28, 2007, 02:08:21 PM: As long as you are sorted out all is well.

Cheers

Den
Title: Re: Taper roller bearings
Post by: spwg on November 08, 2007, 12:18:23 AM: tickety boo?
Title: Re: Taper roller bearings
Post by: SteveD CB500K0 on November 08, 2007, 07:11:15 AM: Aha!

SPWG = Supue Pasty White Guy!

Welcome to this side of the pond.
Title: Re: Taper roller bearings
Post by: FATAL on November 08, 2007, 03:39:57 PM: Quote from: spwg on November 08, 2007, 12:18:23 AM
tickety boo?

It's from ye olde english meaning confuse americans ;D