Show Posts

This section allows you to view all posts made by this member. Note that you can only see posts made in areas you currently have access to.


Topics - 3scs

Pages: [1] 2
1
CB500/550 / 550 K3 rev counter
« on: February 13, 2024, 09:22:34 PM »
I’m looking for a 550 k3 rev counter if anyone has one spare

2
CB500/550 / 550 f2 exhaust
« on: April 22, 2023, 07:23:02 PM »
Managed to get a decent genuine exhaust for my f2 not that there was anything wrong with the stainless motad but I think this just finishes off nicely what was already a cracking bike thanks Trigg and Dave

3
CB500/550 / Tacho drive shim washer
« on: July 16, 2022, 04:51:14 PM »
Hi I’m looking for a tacho drive shim washer part number 90451-292-000 for a 550k3 if anyone has a spare

4
CB500/550 / Cracking tire
« on: September 11, 2021, 04:43:35 PM »
Has anyone had problems with side walls cracking on metzeler me 11 as in the pictures or would you put it down to the age of the tire date stamped 2013

5
CB500/550 / 550k3 front indicator stems
« on: May 05, 2020, 08:55:06 PM »
Does anyone have a pair of front indicator stems for sale I think the part number is 90154-404-610 think they are the same ones as 750 f2 ones thread size is m14x 1.50 also looking for a 550 k3 grab rail

6
CB500/550 / 550 k3 harness
« on: April 05, 2020, 10:24:03 PM »
Just fitting new main harness to my 550k3 it had the wrong harness fitted does anyone know the correct route does it go around the frame or through the centre of the frame

7
CB500/550 / Cb 550 k3 rear light
« on: February 09, 2020, 10:39:40 AM »
My cb 550 k3 when I bought it was made up of loads of bits that don’t belong on it I’m slowly replacing with correct bits as I find them it had what I think was a rear mudguard off a F1 fitted with the rear light unit with the reflectors down the outside edge I’ve acquired what I believe is the correct mudguard and the correct rear light which has the round reflector in the middle was just wondering if anyone knows what the other light unit is off it has a shorter wiring harness than the k3 one I’ve looked on cmsn it shows rear lense with only two screws on the f1

8
CB500/550 / 550 k3 rear light position
« on: August 04, 2019, 10:55:03 AM »
Long story shortened trying to get my k3 (which has quite a few f1/2 parts fitted) as near as it should be I have got a seat to change but didn’t realise grab rail and rear light and mudguard all wrong I have acquired a rear light bracket with indicator mounts but I haven’t got the correct mudguard so for now I want to mount it to black plastic one I have could anyone who has a k3 take a picture with measurements possibly from the back of the seat to the light much appreciated

9
CB500/550 / 550 k3 grab rail
« on: July 27, 2019, 10:57:29 AM »
Was just wondering would anyone know where I could get a rear grab rail for my 550 k3 mine has the f seat and rail fitted I’ve just acquired a k3 seat but it won’t fit because of the rail not as straight forward as I thought just removed grab rail to try seat and I think the rear light bracket is wrong also I think you were right trigg it should have the indicators mounted to rear light bracket so will looking for light mount also, it says it’s the same as 750k7

10
CB500/550 / Cable routing
« on: June 22, 2019, 11:22:52 AM »
Just putting front end back together had forks rechromed and fitted new steering bearings not quite sure where clutch cable is supposed to go is it over or under the speedo bracket it’s a cb550 k3

11
CB500/550 / 550k3 wiring diagram
« on: May 05, 2019, 07:58:06 PM »
Could anyone tell me where I can find the correct wiring diagram for a cb 550k3 uk spec please

12
CB500/550 / Steering lock
« on: February 09, 2019, 11:31:50 AM »
Would anyone know why my steering stem doesn’t have a hole in it for the steering lock it’s a cb 550k3 which has many parts from an f1 fitted to it but according to cmsn the steering stem is the same for both models

13
CB500/550 / 550k3 fuse box?
« on: June 24, 2018, 08:15:39 PM »
Can anyone tell me how many fuses should a 550k3 have mine has four in use and one spare took bike  out for the first time had it running in the garage no problems about 50 yards down the road it cut out no electrics checked over found 15A fuse had blown replaced fuse up and running again found fuse was blowing only when lights were on,all wiring diagrams I can find show only three fuses

14
CB500/550 / 550k3 swing arm?
« on: October 08, 2017, 10:36:45 AM »
i have a cb 550 k3 which has been made up from different parts it has what i think is a swing arm from an f i am trying to make it as correct as possible, the problem i have is i have bought a swing arm which was described as a k3 when i build it up the axle bolt is too short to get the nut on far enough to fit split pin, i have got the correct spacer which appears to be the only difference i was wondering if anyone had a k3 axle bolt they could measure for me thanks
Si

15
CB500/550 / Kill/light switch assy
« on: August 29, 2017, 09:40:49 PM »
After reading the post about twin throttle cables I noticed my so called 550k3 has only one cable on closer inspection I realised the switch Assy is not the correct one there's no kill switch on it and only one hole for one cable does anyone know where I can get correct one from thanks

Pages: [1] 2
SimplePortal 2.3.5 © 2008-2012, SimplePortal