This section allows you to view all posts made by this member. Note that you can only see posts made in areas you currently have access to.
Messages - Bryanj
Pages: 1 2 3 [4] 5 6 ... 672
46
« on: April 12, 2024, 06:24:12 PM »
Eggcup full of parafin wouldve sortrd that! But seriously well done, we just need to hear the running
47
« on: April 12, 2024, 03:34:10 PM »
Dont know why you took it apart, would have run as it was!
48
« on: April 12, 2024, 03:32:03 PM »
400,500,550 all the same mate, whats wrong with yours
49
« on: April 11, 2024, 09:00:38 PM »
I think you are missreading the plastigauge chart or the micrometer ifvit was the gap you say you would probably feel play
50
« on: April 11, 2024, 08:58:32 PM »
The other possibility if ht leads are correct is kinked fuel pipe to 1&2 or a blocked tap outlet to 1&4
51
« on: April 11, 2024, 01:59:58 PM »
Its possible the housing has a small crack due to overtightening the taper thread or it could be the cover plate leaking, nurse julie does O ring kits for the pump
52
« on: April 11, 2024, 01:55:04 PM »
Using a screwdriver usually overtightenes the camchain leading to excessive wear and possible breakage, ifthis is the only way you can doo it then something is broken/siezed and needs fixing
53
« on: April 10, 2024, 11:48:26 PM »
I might be able to use a us contact for you if the rubber is in us
54
« on: April 10, 2024, 07:41:46 PM »
Roo, i have several sets of 500 carbs about and will get some out on saturday for you to borrow mate
55
« on: April 09, 2024, 09:45:45 PM »
As far as i know all the 500 are the same but they do corrode, only place i ever saw them was silver but not cheap. There is a sevice bulletin about clutch adjusters in alladins cave
56
« on: April 09, 2024, 09:43:24 PM »
They are the push in with O rings arnt they mate, if so 100 is atandard 500 so im sure i can find a loner set for you
57
« on: April 09, 2024, 09:42:07 PM »
Not sure if the F2 is there but good parts diagrams at cmsnl just make sure you get the correct model
58
« on: April 09, 2024, 09:40:13 PM »
Never had a problem just knocking them in Ted
59
« on: April 09, 2024, 09:39:00 PM »
Standard stainless not a good idea in high stress positions
60
« on: April 08, 2024, 09:42:52 PM »
The Story
Many years ago Honda dealers had to buy parts from one of several "big" dealers, some of these were Fowlers, Tippets, Skellerns, Bill Smith, Bill Head plus more. If you ordered parts by number any dealer got 20% discount, Honda dealers more.
Now any dealer orders direct from Honda and get whatever discount Honda give
Pages: 1 2 3 [4] 5 6 ... 672
|
Show Posts