1
CB500/550 / Re: CB500 K0 Carbs
« on: May 21, 2019, 07:49:16 PM »
Well I'm still struggling to get the bike to run properly. Re-checked timing and valve clearances but she just feels starved of fuel. Float levels set at 22 mm and all new jets and even removed the fuel strainer and air filter to eliminate these as being a cause of the problem.
Was wondering whether it is possible to fit the emulsion tubes too high in the body of the carb so that the needle valve is closing down the fuel flow too much?
Any thoughts from anyone will be greatly appreciated.
Was wondering whether it is possible to fit the emulsion tubes too high in the body of the carb so that the needle valve is closing down the fuel flow too much?
Any thoughts from anyone will be greatly appreciated.