Honda-SOHC
SOHC.co.uk Forums => CB350/400 => Topic started by: Dolomite_ on January 08, 2024, 09:53:01 PM
-
Im currently stripping the engine and following the haynes manual for it. Ive been trying to remove the primary shaft but it feels like the nut needs a hell of a lot of force to undo.
Is there a way to hold it in place? I've still got the pistons connected and it seems like they're holding it in place when I try to undo it.
Whats the best way to undo the bolt holding the primary shaft in?
-
Put the clutch back on and a penny in the teeth
-
Put the clutch back on and a penny in the teeth
Oooooh....have you seen the price of a new penny nowadays :o
https://www.ebay.co.uk/itm/186006858870 an early one here.
-
Good tip Bryan with the penny! And that one looks as if it has been in about a few clutch teeth Nigel! Take it that’s a typing error on the price?
-
If you cant afford the penny, and i couldnt. A copper washer or even alloy will do, just when i was in workshop as most lazy maniacscdid just put hand in pocket
-
Must be nonesance price, we had an almost mint presentation set from back in 1971 face value was less than a £1 issued by the banks & Post Office IIRC. We gave ours to my daughter a couple of decades ago with a load of farthings & a Guernsey 50p coin.
-
As we race towards becoming a cashless society good luck with jamming the mobiles in the teeth! 😂😂