61
CB750 / Re: Engine shop recommendations West Yorkshire
« on: June 18, 2020, 09:41:48 PM »I would take caution on reboring firms .. a lot of them don't work to Jap bike tolerances. You won't go wrong if you go to Trigger & Julie for at least rebore & head work. ....plus a very tranquil and charming part of the country to visit and always a warm welcome there. As you will gather from the banter they are quite popular on here.Thanks Ash. Glad I joined this group. Lots of useful leads already
Also, if you are shopping around for pistons make sure the +0.25mm is enough for the wear on your bores (or they have not been bored already). Quite often if there has been water or rust damage or ring breakage you will need to go up two rebore sizes.
Sent from my ONEPLUS A6013 using Tapatalk