This section allows you to view all posts made by this member. Note that you can only see posts made in areas you currently have access to.
Messages - SteveW
16
« on: March 16, 2024, 01:56:21 PM »
I ordered a set of 3 magnetic trays from Toolstation a couple of years ago. I don’t think they realised they were magnetic and I got 6.
17
« on: March 08, 2024, 09:53:27 PM »
When I did my 650 top end, with the rocker cover off and the plugs out I spun it over gently on a battery drill.
18
« on: March 08, 2024, 09:19:49 PM »
I might be going tomorrow, if so I’ll pop over and say hello.
19
« on: March 07, 2024, 07:07:56 PM »
What about the low temp aluminium brazing rods on eBay?
I’ve used them before and they are pretty good.
20
« on: March 07, 2024, 10:43:34 AM »
I think Nurse Julie had a couple of these for sale recently.
21
« on: March 06, 2024, 01:12:28 PM »
That’s good to know, I’m not ready to fit mine yet. Mines currently still boxed on the kitchen floor, missus is not happy. But then she rarely is 
22
« on: February 29, 2024, 10:11:29 PM »
I need to refine mine a bit, the polyurethane I used is way too hard.
23
« on: February 29, 2024, 02:14:07 PM »
3 of the rubbers holding my battery box on my 550 are shot.
They are not available so I thought I’d make some.
Made a 2 part mould in the lathe and got some polyurethane liquid rubber stuff.
For a first attempt it came out a treat and there was no shrinkage.
The new one is a slightly different shape because it was done on the lathe. May get a new mould 3D printed so it will be the correct shape.
Top pic is the old one.
24
« on: February 29, 2024, 01:29:38 PM »
My mate has just placed an order from these guys, I’ll let you know what they’re like when they arrive. He’s ordered stainless for his RD250 https://e-spokes.eu/
25
« on: February 29, 2024, 12:58:02 PM »
I’ve got these, very good
Www.carbtune.com
26
« on: February 24, 2024, 11:09:18 AM »
Just checked all 4 pipes, no markings of any kind.
FYI, kit comes with everything you need. Brackets, bolts, copper sealing rings, clamps and collars.
Even the rubber bump stops for the stands.
It’s a lot of money but a hell of a lot cheaper than the other source of these.
27
« on: February 24, 2024, 09:15:08 AM »
I’ll check them later on and let you know.
28
« on: February 23, 2024, 06:56:48 PM »
Well, it’s arrived and is absolutely gorgeous.
So you're pleased with it then Steve 😁😁😁
Yep, might hang it on the wall instead 
30
« on: February 23, 2024, 05:04:54 PM »
Well, it’s arrived and is absolutely gorgeous.
|
Show Posts
