Honda-SOHC

SOHC.co.uk Forums => CB350/400 => Topic started by: gtmdriver on September 10, 2015, 11:00:07 AM

Title: 350F Cush Drive Rubber Removal.
Post by: gtmdriver on September 10, 2015, 11:00:07 AM

As it says in the title.

I am reconditioning the rear wheel, hub and brakes and I have a set of 4 new cush drive rubbers.

Can anyone tell me if there is a way to remove the old rubbers without burning them out and then trying to collapse the outer sleeve without damaging the alloy surrounding them?

Title: Re: 350F Cush Drive Rubber Removal.
Post by: tom400f on September 10, 2015, 12:10:41 PM

http://www.sohc.co.uk/index.php/topic,6795.msg37893.html#msg37893
http://www.sohc.co.uk/index.php/topic,6318.msg33536.html#msg33536

 ;)

Title: Re: 350F Cush Drive Rubber Removal.
Post by: gtmdriver on September 10, 2015, 06:04:02 PM

Thank you!

As it turns out this will have to go on hold as the rubbers I bought on ebay are not the correct size even though they were specified for my bike.

Serves me right I suppose.

Title: Re: 350F Cush Drive Rubber Removal.
Post by: tom400f on September 10, 2015, 10:12:31 PM

No - there are a lot of plonquers on Ebay