This section allows you to view all posts made by this member. Note that you can only see posts made in areas you currently have access to.
Messages - Bryanj
Pages: 1 2 [3] 4 5 ... 675
31
« on: May 02, 2024, 08:05:44 PM »
Dave, its only the later ones with a rubber seal, early ones the seal is the felt ring, i think i still used the caps with the bronze bushings though
32
« on: May 02, 2024, 08:04:05 PM »
Only thing i can think off is either something between case and shell or the disaster of a bent crank, i have built engines with all black shells with no rotational problems
33
« on: May 02, 2024, 08:01:17 PM »
But no hallway ornaments!
34
« on: May 02, 2024, 01:22:38 PM »
You didnt oil the back of the shell did you?
35
« on: May 01, 2024, 06:45:48 PM »
Sold or pulled
36
« on: May 01, 2024, 05:08:56 PM »
Usually you find the collar more worn than the bushes, the early one is still available, but bloody expensive, the later one is not available but you can use the early one, preferably with the bolt having a grease nipple at each end rather than the one in middle of swing arm
37
« on: May 01, 2024, 05:03:57 PM »
It only says new stainless exhaust NOT original
38
« on: May 01, 2024, 05:00:43 PM »
Boyer fire all the plugs all the time
39
« on: May 01, 2024, 04:59:06 PM »
As my wife suffers from ME what annoys us is the symptoms are VERY similar but ME sufferers get no help at all, long covid seems to be getting lots of help
40
« on: April 29, 2024, 11:36:32 AM »
A lot of us people will not be happy as they are waiting for 750 units
41
« on: April 29, 2024, 11:10:19 AM »
Same system
42
« on: April 28, 2024, 03:46:23 PM »
It never has in all the years i been doing them, BUT i do make sure the nut runs free
43
« on: April 28, 2024, 03:44:46 PM »
Why not? If you can design for whole numbers you can design for half way
44
« on: April 27, 2024, 10:30:19 PM »
You dont ever use the slot anyway, when building before fitting cam stick fingers down tunnel, push slipper to carbs and hold whilst nipping up locknut then just undo when built and holding pressure on kickstart, nipping up whilst holding pressure.
Check the tensioner fold over tabs are crimped over tight to hold theteeth on the bolt in mesh with the rack, people forcing the screw slot in the false idea that this will tension the chain is what damages the meshing in the first place
45
« on: April 27, 2024, 09:46:05 PM »
As long as the nut screws on leave it alone as you dont need that slot
Pages: 1 2 [3] 4 5 ... 675
|
Show Posts