Push cable usually has no adjuster, so just fit and leave. But that one shouldn't give you a problem unless something is misplaced on brackets.
As it has an affect when you push the top of slides it may be that there's not a parity of the slide home position from assembly. Are you familiar with Bryan's bench synchronisation method? As that should remove an error like that if present.
Thank you so much!! And thanks to you Bryan as well..
So last night I whipped the carbs off and bench synced them using a red tipped welding electrode 1.6mm (1/16) adjusted all the floats again and went through the jets with a guitar string.
Popped them back on and it’s purring like a kitten.. idle drops back down responsively and it’s sounds great!!
I have the air/fuel mix screw out 1 turn and it seems bang on!
Not had chance to get her on the open road Yet but it’s a far cry from what I was dealing with!!
Once again this forum comes to the rescue! What would I do without you guys!
If you lived closer I’d get you a pint!!
I’ll keep you posted after the run out but needless to say I am very excited!!!
I’ll be clapping for you guys on Thursday night!!!
Cheers
Alan