91
CB350/400 / Re: Transmission output shaft bearing removal
« Last post by Dolomite_ on May 26, 2024, 08:16:22 PM »A stupid question but is the roller bearing damaged and worn? The gearbox on Ratty had over 45k on it (probably over 50k as the PO had fitted a mini Speedo on the bike at some point). When I checked the roller bearings they were fine, no play, no nasty rumbling and no tight spots. The rest of the engine was in a terrible condition as a result of the PO blasting it with a sand gun. The roller bearing was good to go again but unfortunately the shaft was worn beyond repair and I purchased the two gear shafts from Ted. I have no idea how many miles were on that gearbox but again the roller bearings were absolutely fine.
The bearing doesn't feel great, quite gritty when spinning it.