Show Posts

This section allows you to view all posts made by this member. Note that you can only see posts made in areas you currently have access to.

Topics - ewanhughes

Pages: [1]

Project Board / Defiinition of an optimist?

« on: March 01, 2023, 11:01:51 AM »

I like to think of myself as a glass half full kinda person but even i'm struggling with this one.

Does this even make the "basket case" category?

Anyone on here up for a challenge?

https://www.ebay.co.uk/itm/195629197451?hash=item2d8c68a88b:g:0CYAAOSwSlxj~mFo&amdata=enc%3AAQAHAAAAkIcLzFVp1GMuXUCq4a%2F9B5MbJS0Fle2bgofn6KayfirvVOTlOiFM4EXmAJtM6Oi%2BH%2BOIOiZ5pSWqMaGrPAdxkAiCS6jq2v%2FESh%2F7hfQEpdrNqge%2FxcbpGy51mC235f3%2BjIYVsst2GV1Cruu6RPEz6r23vem73pRww%2FWOJAX6yx3k2BryZeKudrl4ZoNaEHGXyQ%3D%3D%7Ctkp%3ABk9SR5DU6MzTYQ

CB500/550 / 550f1 decal positions

« on: February 15, 2021, 04:57:09 PM »

Does anyone know if there is a similar diagram for the 550f1?

CB500/550 / Black Hole in Reverse

« on: October 27, 2020, 03:24:12 PM »

1976 CB550f1

Ok so I finally managed to separate the cylinder head from the welded on gasket and got it onto the bench.
After a few twists and turns and summersaults checking the fins, valves and the inch thick grot I noticed these 2 rubber grommets/pucks sitting on the bench. I do have a black hole in my mancave that eats dropped nuts bolts and washers but so far i've never had anything returned from the parallel universe.

Can any of you fine people on here offer any suggestions as to where they came from so i can return them to their rightful home before i put the cylinder head back on.
Thanks

Kenny

Recommended Sources for Parts and Services / 400/4 Decals

« on: February 03, 2012, 09:26:40 AM »

I'm looking to buy a complete set of tank and side panel decals for my 400/4.

Anyone out there have any suggestions as to the best place to buy them?

Anywhere that's better than the rest, or to be avoided like the plague?

Cheers

Kenny