Honda-SOHC
SOHC.co.uk Forums => CB500/550 => Topic started by: jon stead on May 22, 2018, 05:00:25 PM
-
Hi, anybody got any of the tools from the tool kit for sale?
Looking for anything on the attached image, except the items marked with a red cross.
-
Hi that would be great, thanks.
26mm, for the rear wheel nut. I’m guessing that’s the one they refer to as the sleeve spanner - items 13 and 14 on the previous drawing.
Yes, 26mm, as Seabeeowner pointed out below.
-
Have you seen this I think is same kit
https://rover.ebay.com/rover/0/0/0?mpre=https%3A%2F%2Fwww.ebay.co.uk%2Fulk%2Fitm%2F352204010410 (https://rover.ebay.com/rover/0/0/0?mpre=https%3A%2F%2Fwww.ebay.co.uk%2Fulk%2Fitm%2F352204010410)
-
Is that a typo Jon, wheel nut and spanner are 26mm on the 500s and early 550s? And 24mm on 550K3 and 1978.
I've built up sets partly from ebay and partly buying some new. I did get one pristine set with a bike that only has a tiny mileage and am in contact with the 40+year owner. And the tools supplied were not exactly as CMS shows for that bike.
Still need one of the sleeves that slides over the wheel nut spanner if anyone has a spare.
-
Have you seen this I think is same kit
https://rover.ebay.com/rover/0/0/0?mpre=https%3A%2F%2Fwww.ebay.co.uk%2Fulk%2Fitm%2F352204010410 (https://rover.ebay.com/rover/0/0/0?mpre=https%3A%2F%2Fwww.ebay.co.uk%2Fulk%2Fitm%2F352204010410)
Yes I’d seen that earlier but I think it’s a bit expensive seeing as how it’s incomplete.
-
You could have a new set from DSS for £66 +carriage. But bizarrely and stupidly it says you don't get the axle wrench (or presumably the extension shown above) as after 2034711 it was excluded.
https://www.davidsilverspares.co.uk/CB500K1-FOUR-1972/part_191214/