Honda-SOHC
SOHC.co.uk Forums => CB350/400 => Topic started by: billdn on June 03, 2018, 03:34:37 PM
-
While fitting new carb balancing screws, well that's what I think they are, 1 of the little beggars is just spinning and not tightening. Thread is good on screw , described as 5 x 6mm pan screw. I'm tempted to blank it off but would negate balancing carbs or that one later! Any ideas I'm thinking another helicoil required 😒 Photos attached to show location.
-
M5 helicoil kits on fleabay
-
I had 2 of them go on my carbs, little blighters. Trig sorted it but I think if you're doing it with the carbs on the bike, swarf getting in is the biggest problem.
Just seen yours are off the bike, so forget that last comment ;D
-
Tap to 6mm with loads of grease ;)
-
Cheers All, 1 helicoil kit purchased and on it's way.
-
Quick PS helicoil worked ;D