This section allows you to view all posts made by this member. Note that you can only see posts made in areas you currently have access to.
Messages - Pauarc
Pages: 1 ... 9 10 [11] 12 13 14
151
« on: June 30, 2023, 07:50:46 PM »
When you fit keyed washer should it have be loose on shaft I have douts the fin washer was there I think I am going to take the clutch out to find out if it’s there
152
« on: June 30, 2023, 04:57:55 PM »
If the fin washer is missing behind basket could this effect the clutch I can’t remember seeing it
153
« on: June 30, 2023, 09:58:58 AM »
I have just set central nut as you suggested have not tried yet as out today
154
« on: June 30, 2023, 07:56:11 AM »
The clutch drag a bit before and gear change was clunky old plates were hard not any better with new plates no thin washer that I can remember but there was a thick washer
155
« on: June 29, 2023, 09:01:02 PM »
I just checked the old ones they are 31.5 mm the new ones are 31.9mm I made a note and yes flat side in and bevelled side out.
this is the length off springs in the manual I have
156
« on: June 29, 2023, 08:12:43 PM »
Before I fitted new plates I put the steel plates in a ultrasonic cleaner springs are new
157
« on: June 29, 2023, 07:44:12 PM »
This was before I fitted new chork plates
158
« on: June 29, 2023, 07:39:58 PM »
My bike is a Honda CB750k2 1975 all straight plates
159
« on: June 29, 2023, 06:51:07 PM »
I have no double steel plate what would this do
160
« on: June 29, 2023, 12:38:55 PM »
Just a thought could it be the oil any suggestions on that
161
« on: June 29, 2023, 12:13:35 PM »
I will try that at weekend I have tried it in different ways but will have a go that way
162
« on: June 29, 2023, 10:35:32 AM »
I have now fitted new EBC clutch plates (ck1133). I have also checked steel plates for Warpage (I lay them on a sheet of glass) no Warpage I could measure with a feeler gauge. Also have put putoline S4 mineral oil 10w40 in bike.The clutch still drags I have adjusted bolt in then out 1/4 turn 25 mm free play on leaver I have even tried adjusting bolt with no slack clutch plates seem to be sticking together any ideas
163
« on: June 26, 2023, 05:35:17 PM »
With engine out Is it possible to split the gear box without removing the head so I can change the tensioner in the sump
164
« on: June 15, 2023, 07:55:09 AM »
Now striped
165
« on: June 11, 2023, 10:02:58 AM »
Should you soak new clutch before you install them
Pages: 1 ... 9 10 [11] 12 13 14
|
Show Posts