This section allows you to view all posts made by this member. Note that you can only see posts made in areas you currently have access to.
Messages - Pauarc
Pages: 1 ... 10 11 [12] 13 14
166
« on: June 06, 2023, 04:36:50 PM »
Do clutch plates go hard and would this make them drag?
167
« on: June 06, 2023, 12:49:33 PM »
I’m going to see my friend I will see if he may have a part number l haven’t fitted them yet but he told me that they just prize and the new ones just push in
168
« on: June 06, 2023, 12:42:22 PM »
I have noticed that the clutch basket is different from manual ?
169
« on: June 06, 2023, 12:40:05 PM »
Have now decided to take the clutch apart all plates measure 3.58 and no plate warpage
170
« on: June 04, 2023, 08:47:26 AM »
A mate who used to work for a Honda bike shop in the 70s had some of the top grommets so carb are coming off to try them
171
« on: June 02, 2023, 12:19:28 PM »
Could this top seal be giving a vacuum leak as it’s damaged
172
« on: June 02, 2023, 10:09:35 AM »
Could this top seal be giving a vacuum leak as it’s damaged
173
« on: May 31, 2023, 01:10:05 PM »
Turned no 1 out a little more now all same colour but the tic over uneven if set at 1000 not sure 🤔 what maybe the problem runs well otherwise
174
« on: May 30, 2023, 04:59:21 PM »
After a 30 mile run a bit better I think they are looking better now not sure if they may be a bit weak now?
175
« on: May 30, 2023, 03:24:28 PM »
All plug set to 1-1/8 out on air screws going to try no1 out a bit more
176
« on: May 27, 2023, 09:20:47 AM »
I will have to try 1and 1/8th and see they are all at 1 now which gave me a tick over of 1000 carb have been vac sync but they are all sooty
177
« on: May 26, 2023, 08:03:22 PM »
What have you got the air screws set at now martin6
178
« on: May 26, 2023, 09:23:57 AM »
With spark tester they jump 10mm should be 7mm min I think
179
« on: May 26, 2023, 08:50:34 AM »
Plugs set loose .6mm should be .6 to .7
180
« on: May 26, 2023, 08:12:12 AM »
Compression all around 160, float set 26mm, needles on 3 grove, air screws 1-1/8th out, 40 slow jet 120main I have got some 110 coming
Pages: 1 ... 10 11 [12] 13 14
|
Show Posts