This section allows you to view all posts made by this member. Note that you can only see posts made in areas you currently have access to.
Messages - Pauarc
Pages: 1 2 3 [4] 5 6 ... 14
46
« on: December 23, 2023, 01:13:43 PM »
So cb750e-2382187 would be right for 1975 feb then
47
« on: December 23, 2023, 11:47:03 AM »
Has anyone got a list for British Honda cb750k1-6 engines
48
« on: December 15, 2023, 09:00:48 AM »
Hi Martin
it’s great to hear bike back together hope the first run out goes smoothly good luck Paul
49
« on: December 09, 2023, 08:19:20 PM »
I no it’s odd the gtx oil is the last thing to try this is a page from Honda workshop manual from the 70s if this doesn’t sort it looks like I will have to take engine out and look at gearbox I don’t know what else it could be
50
« on: December 06, 2023, 05:58:39 PM »
I have done the clutch mod I have changed oil need a nice day to try it out will have to see if any better will keep you posted
51
« on: December 05, 2023, 09:50:34 AM »
I just emailed Castrol about ma spec oil and they replied I don’t know if the info is any help
52
« on: December 04, 2023, 05:19:13 PM »
Castrol GTX 10w40 mineral That the oil I used in the 70s and 80s on all my bikes
53
« on: December 04, 2023, 11:10:14 AM »
Update all back together still clunky between gears goes into neutral okay I found a note in the Honda manual about viscosity of the oil given drag on the clutch so now going to try some Castrol GTX 10w40 classic for classic bikes, and cars also going to check the oil pump strainer in sump. Would it be a good idea to change the O-rings where the pump meets The engine
54
« on: November 28, 2023, 11:04:13 AM »
I don’t know I just wish I found something just cleaned out galleries with bottle brushes but until I get clutch cover gasket I won’t know finally if it’s sorted it
55
« on: November 28, 2023, 10:56:02 AM »
Update I have oil getting to clutch also pic of bang just waiting for gasket hopefully it made a difference in gear change
56
« on: November 24, 2023, 05:45:24 PM »
I have already fitted a new oil ring and left hand bearings plate I was going to try spinning bike over with the bung out (kill switch off) to see if oil comes out where bung goes then put bung in and see if it get to bearing if it does I will fit gear change and cover and try running the bike and see if it gets to clutch
57
« on: November 24, 2023, 03:20:27 PM »
I have had a bright spot light shining through from clutch side and it shines through onto a piece of paper and also a long pipe brush down the centre to other side and a air line as well
58
« on: November 24, 2023, 01:47:17 PM »
Do you think it’s would be ok to run with cover off to see if oil comes out of the hole in centre of clutch after fitting gear shaft bearing and plug
59
« on: November 24, 2023, 01:41:07 PM »
All cleaned and blown through and clears found nothing which would be blocking it
60
« on: November 23, 2023, 07:41:10 AM »
Thanks Martin I will bear that in mind how The bike going
Pages: 1 2 3 [4] 5 6 ... 14
|
Show Posts