This section allows you to view all posts made by this member. Note that you can only see posts made in areas you currently have access to.
Messages - Pauarc
Pages: 1 ... 4 5 [6] 7 8 ... 15
76
« on: November 08, 2023, 08:34:37 PM »
Does anyone know what size thread the oil switch is
77
« on: November 07, 2023, 08:29:46 PM »
I have looked at the outer basket and it had a bit of pitting where the friction plates run I run a fine file over them also I noticed that the new friction plates had sharp edge so I filed them off have to see if that helps
78
« on: November 02, 2023, 08:27:10 PM »
The spacer is in there as charged stoper ring thanks Skoti
79
« on: November 02, 2023, 04:06:28 PM »
I just looked on bike cover still off I see what you mean but the front and back line up spot on also there’s alignment Dowls I just think it’s the clutch dragging going to strip the clutch again and look at basket as Martin spotted marks on the outer
80
« on: November 02, 2023, 12:19:21 PM »
Picture of linkage can anyone see any problems
81
« on: November 02, 2023, 10:10:48 AM »
Hi Martin
Well spotted will have to check may be flash giving a shadow look at some other pictures can’t see it but I will have to check
Thanks for your reply how’s your engine going
Paul
82
« on: November 02, 2023, 07:50:40 AM »
Should you be able to just pull clutch outer off when you remove thrush washer mine fit loose (after removing plates)
83
« on: November 01, 2023, 08:41:59 PM »
Bike drag’s and clunky when selecting 1st then if I change up the box slowly not to bad odd times it may miss a great but not the same gear when coming down the box clunky and hard to change some time it goes into neutral ok get worse after a run and bike get hot tried setting adjuster with no gap no difference just slips
84
« on: November 01, 2023, 07:15:29 PM »
Bad changing on all gears get worse when hot
85
« on: November 01, 2023, 06:49:47 PM »
Yes I been through selector mechanism change some of that I did notice that there not a lot of oil around the clutch
86
« on: November 01, 2023, 06:07:43 PM »
I am clutching at straws now just can’t get a good gear change have fitted new clutch plates and steel plates I also change the adjuster in the clutch new cable I may try castrol gtx classic 10w40 mineral which has got zddp in it but it looks like engine out and look at gearbox is there any other options
87
« on: November 01, 2023, 02:46:29 PM »
Does anyone know if Motul 3000 4T 10w40 Mineral Oil has got zddp in it or can it be added and would it be worth adding
88
« on: October 29, 2023, 05:07:23 PM »
Hi Martin
Part fish for head
Paul
89
« on: October 13, 2023, 04:40:25 PM »
Honda CB750f2n then now CB750k2
90
« on: October 10, 2023, 09:18:10 PM »
Hi Martin
I had a similar issue with a cb550 I managed to get the gasket face skimmed and put two gaskets there maybe it will be possible for you
Paul
Pages: 1 ... 4 5 [6] 7 8 ... 15
|
Show Posts