This section allows you to view all posts made by this member. Note that you can only see posts made in areas you currently have access to.
Messages - Fenderfreak
31
« on: October 14, 2018, 10:43:23 PM »
Just started pulling the motor apart on my cb250k3 and looking for list of tolerance/ service limit measurements for engine components.
Anyone know where I find this info? Had a look on Ash’s list but may have missed it.
Also noticed signs of wear on the inners faces of the rotor, not major but can see where it may have been touching the rotor, is this normal? If not what causes it?
Cheers
32
« on: August 09, 2018, 01:51:35 PM »
It’s getting there, rebuilding the seat this afternoon😀
33
« on: August 09, 2018, 09:34:41 AM »
Finally on its own two wheels
34
« on: July 03, 2018, 09:45:47 PM »
Anyone recommend an engine stand for a twin?
Ta
35
« on: June 30, 2018, 11:10:52 PM »
Quick update, rolling chassis nearly done, then can start stripping down the engine 😉
39
« on: May 05, 2018, 10:50:08 PM »
Excellent! Thanks!
New set ordered.
40
« on: May 05, 2018, 05:13:13 PM »
Can anyone recommend replacement rear damper and spring units fir my CB250K3?
Many thanks
41
« on: April 17, 2018, 04:26:41 PM »
Thanks Ash, great resource. Now in my favourites 👍
42
« on: April 16, 2018, 11:50:00 PM »
Thanks Ash 👍
I’ll give them a go
43
« on: April 16, 2018, 04:20:39 PM »
Anyone know if other models down pipes will fit my 71 CB250K3?
Having difficulting locating a set, mine are beyond repair as corrosion has left pits the size of the Grand Canyon.
Ta!
44
« on: April 11, 2018, 02:16:08 AM »
Done, worth every penny 👍
45
« on: April 10, 2018, 10:14:45 PM »
Excellent thanks
|