This section allows you to view all posts made by this member. Note that you can only see posts made in areas you currently have access to.
Messages - Bryanj
1
« on: Today at 09:04:51 PM »
It shouldnt, the only connection is through the small red wire from terminal with battery cable to fuse
2
« on: May 24, 2024, 05:10:42 PM »
In theory, with main jet removed it should push down from the top but i havent gone that far with pd carbs, i usually point blank refuse ro work on them.
3
« on: May 24, 2024, 01:00:47 PM »
Yes they are pressed on, is the bike going to be a daily driver high mileage or an ocasional weekend use?
If 1 i would pay out
If 29 i would put engine oil in them and if smooth and quietish use them as if it dont work you only need lower case off to replace and your time
4
« on: May 23, 2024, 02:14:42 PM »
Glad to hear shes back running Ted
5
« on: May 22, 2024, 02:09:59 AM »
Thats the big difference mate, old british iron was designed for ocasional sniff of the red but japanese was built to have its neck wrung, can remember the exact wording but the 500 owners handbook says it is fine to go into the red but not out of the top for extended periods!
6
« on: May 21, 2024, 08:58:44 PM »
Instead of using a torch put it on the hob when the boss isnt looking
7
« on: May 21, 2024, 07:42:32 PM »
6000 is no where near the red line and dont think its anywhere near the 85% i would cruise at, cameras permitting!
8
« on: May 21, 2024, 07:40:08 PM »
No always anneal, just be carefull not to melt it!
9
« on: May 21, 2024, 07:22:22 PM »
Yes but dont remember the small hondas having copper gaskets
10
« on: May 20, 2024, 10:47:51 PM »
Honda part numbers are not complicate, the first numbers tell you what it is, the middle three what model first used on last three manufacturer or country code or supercision code so 283 is the model code you need, the supplier said sounds like 280 which is different
11
« on: May 20, 2024, 10:13:57 PM »
Part number is 41201283000 so i would say 283 not 280 but that is a pure guess
12
« on: May 20, 2024, 08:01:32 PM »
Yes it matters and should be marked if genuine
13
« on: May 19, 2024, 09:49:04 PM »
Just got to work and was going to suggest standard bars might help
14
« on: May 19, 2024, 07:28:22 PM »
That was a good haul, too much and too far away for me, at least 3 of the rear brake pedal retun spring in there
15
« on: May 19, 2024, 01:05:26 AM »
Honda always list alternate sprockets but they were designed with a ratio and yes, compared to british iron, they do seem to rev high BUT its higher up the rev band they give rated power, the 500 handbook says not to go out of the top of the red too often
|
Show Posts