16
CB750 / Alternator harness
« on: January 06, 2017, 11:37:33 AM »
have tried to refurbish mine which is the original alternator wire harness, however the wires are brittle and have split where exiting the engine/spoket cover, therefore i have two options one i make my own, have connectors and spade terminals, just need to order wire, or i could purchase one. seen one on CMSNL for €25 plus postage, DSS has them also, but i will need to amend to fit to new loom setup. best to make one?. has anyone done this before and worked out ok?. the only problem i see is the protective sheaf which was rubber over woven, i can't see that anywhere, any clues?. will order parts from either vintage connections or vehicle wire products which i done so previously with good results. also will be fixing choke cable under the frame out of the way of the original fixing point by handle bars, any one make small length of choke cable? or done this previously here.
thanks in advance
thanks in advance