This section allows you to view all posts made by this member. Note that you can only see posts made in areas you currently have access to.
Messages - Davelu88
16
« on: July 20, 2023, 12:34:56 PM »
To be honest I have never seen it move as I think the movement is minimal, it has never leaked or moved at all since I have been riding it 
17
« on: July 20, 2023, 11:20:26 AM »
Hi , no it is a bracket to bottom of suspension.
18
« on: July 19, 2023, 07:58:15 PM »
Reduced to £3000
19
« on: July 18, 2023, 12:13:52 PM »
Another pic
20
« on: July 18, 2023, 12:07:19 PM »
Hi Selling my 75 plate 550F was an import but UK reg now , loads done last year frame & swingarm powder coated , new bronze bushes , new headstock bearings & races , seat , indicators , handle bars , ignition , paint , left side switch gear , plus lots more i have forgot . Has a normal wheel on the rear now and not the wide rim as in the pics i do have some of the other bits that came off it , grab rail fender stays , rear light , it does have a Kerker exhaust which is great & i believe quite expensive . had some new seals in carbs and i put them through the ultrasonic cleaner , tank is mint inside. message if anyone got any questions. £2750
Dave
21
« on: June 30, 2023, 04:18:29 PM »
No.money gone out yet so I guess I have to wait a bit longer , I just want to get it registered as I do not want to pull.it apart yet in case the DVLA want to inspect it.
22
« on: June 30, 2023, 03:33:17 PM »
Anyone know how long a dating certificate from VJMC is taking nowadays 🤔
23
« on: May 16, 2023, 05:23:19 PM »
Success with the centre stand method , it freed it in no time . Many thanks to all
24
« on: May 15, 2023, 08:07:54 PM »
Some pics of what I have been doing
25
« on: May 15, 2023, 06:11:21 PM »
I will report back tomorrow 
26
« on: May 15, 2023, 05:49:31 PM »
Many thanks , I havehad on centre stand with back wheel spinning but no joy but will give another go tomorrow, am I right turning the adjustment screw to the rear to feel resistance as tur ing it towards the front just loosens it constantly 😀
27
« on: May 15, 2023, 05:08:25 PM »
Hi all , my 550 F is stalling and lurching forward when put in gear , I have tried to adjust at both ends and turned the adjuster screw till it gets resistance but to no avail . The clutch arm is moving freely and I made sure the little notches lined up , could the plates be stuck as not ridden for a bit while refurb took place . Any help appreciated 🙏
28
« on: April 24, 2023, 08:09:27 PM »
Many thanks Ken 
29
« on: April 24, 2023, 06:52:16 PM »
DS do a clamp on ignition bracket for the 750 that's looks .Iike it will fit.
30
« on: April 24, 2023, 06:44:20 PM »
I will have to fab a ignition bracket and a speedo one then powder coat them , I was going to use the honda speedo as I know it's correct speed etc.
|
Show Posts