Show Posts

This section allows you to view all posts made by this member. Note that you can only see posts made in areas you currently have access to.


Topics - pje750

Pages: [1]
1
CB750 / Clutch noise
« on: May 19, 2012, 11:10:02 PM »
Hello, finally completed rebuild of my K2. All is good apart from slight graunchy noise when I pull in the clutch. Is it likely to be a bearing? If so, is it an engine out job? :(

2
CB750 / Rear suspension lower bush
« on: October 02, 2011, 10:04:38 PM »
Hi, have just had my frame and swinging arm re-sprayed and decided to fit new bushes in the swing arm for the rear suspension units. But the new replacements seem to be too large to go in - have made sure the holes in the swing arm are clean, and the bushes are the right part number. But they still won't go in - do they need heat or pressing in? Any help/advice appreciated. Cheers. Pete

3
CB750 / Carb Refurb
« on: July 03, 2011, 10:31:13 PM »
Can anybody recommend anyone who refurbs carbs  - ultasonic clean, carb kit and set-up etc . Cheers

4
CB750 / Wiring
« on: May 30, 2011, 08:55:14 PM »
Hello, does anybody know where I can get the black plastic cover that goes over the wiring? Thanks

5
CB750 / Help! - Rear Suspension Frame Mount
« on: March 29, 2011, 09:33:24 PM »
Help, I could do with some advice - just sheared the mounting threaded stud on the frame where the top of the rear suspension connects. I'm assuming I'll have to drill out, helicoil and fit a new stud/bolt - does that sound right? will it be strong enough? Any advice gratefully received. Cheers

6
CB750 / K2 rear Mudguard
« on: March 28, 2011, 01:09:38 PM »
Hi, the rear mudguard on my K2 is pretty naff - could probably strip and re-chrome etc but lilkely to cost more than a replacement K0/K1 version from David Silver (

Pages: [1]
SimplePortal 2.3.5 © 2008-2012, SimplePortal