This section allows you to view all posts made by this member. Note that you can only see posts made in areas you currently have access to.
Messages - pje750
Pages: [1]
1
« on: May 19, 2012, 11:10:02 PM »
Hello, finally completed rebuild of my K2. All is good apart from slight graunchy noise when I pull in the clutch. Is it likely to be a bearing? If so, is it an engine out job? 
2
« on: October 13, 2011, 10:21:42 PM »
Thanks - you were right. It appears that the outer part of the old bush had seized and hadn't been removed. Difficult to spot, so thanks for the tip. Cheers. Pete
3
« on: October 02, 2011, 10:04:38 PM »
Hi, have just had my frame and swinging arm re-sprayed and decided to fit new bushes in the swing arm for the rear suspension units. But the new replacements seem to be too large to go in - have made sure the holes in the swing arm are clean, and the bushes are the right part number. But they still won't go in - do they need heat or pressing in? Any help/advice appreciated. Cheers. Pete
4
« on: July 03, 2011, 10:31:13 PM »
Can anybody recommend anyone who refurbs carbs - ultasonic clean, carb kit and set-up etc . Cheers
5
« on: May 31, 2011, 10:13:42 PM »
Brilliant thanks, just what I wanted
6
« on: May 30, 2011, 08:55:14 PM »
Hello, does anybody know where I can get the black plastic cover that goes over the wiring? Thanks
7
« on: April 04, 2011, 09:32:29 PM »
Thanks for the advice. My local motorcycle frame engineering place has drilled out and fitted a high tensile bolt. According to them, it will be stronger than the other side! lets hope so. Cheers. Pete
8
« on: March 29, 2011, 09:41:13 PM »
Thanks, appreciate the advice - I'm on the lookout. Cheers
9
« on: March 29, 2011, 09:33:24 PM »
Help, I could do with some advice - just sheared the mounting threaded stud on the frame where the top of the rear suspension connects. I'm assuming I'll have to drill out, helicoil and fit a new stud/bolt - does that sound right? will it be strong enough? Any advice gratefully received. Cheers
10
« on: March 28, 2011, 01:12:11 PM »
I'd like one - can you PM me details. Thanks
11
« on: March 28, 2011, 01:09:38 PM »
Hi, the rear mudguard on my K2 is pretty naff - could probably strip and re-chrome etc but lilkely to cost more than a replacement K0/K1 version from David Silver (
Pages: [1]
|
Show Posts