16
CB500/550 / Re: Dynatek leads and stock plug caps
« on: December 20, 2016, 06:07:16 PM »
Cheers guys just wanted to check as have a set of caps if need. Will run the dyna caps and see.
Try our new info resource - "Aladdin's Cave" (Main menu)
Just added a separate link to Ash's Dropbox thread (shortcut)
This section allows you to view all posts made by this member. Note that you can only see posts made in areas you currently have access to.
Pages: 1 [2]
16
CB500/550 / Re: Dynatek leads and stock plug caps« on: December 20, 2016, 06:07:16 PM »
Cheers guys just wanted to check as have a set of caps if need. Will run the dyna caps and see.
17
CB500/550 / Dynatek leads and stock plug caps« on: December 20, 2016, 03:45:26 PM »
Hi guys dumb question time. Fitting 5 ohm dynatek coils and dynatek leads which have plug caps pre formed, any need to cut pre formed caps off and fit ngk 5 ohm caps?
Cheers gordon 18
CB500/550 / Re: Rough Running advice needed -- at wits end« on: October 14, 2016, 11:36:01 AM »
Cheers for that great description Paul, guess I'm in the garage this weekend.
19
CB500/550 / Re: Rough Running advice needed -- at wits end« on: October 13, 2016, 02:54:06 PM »Progress updateCould give a description of where to clean the idle circuit 20
CB500/550 / Re: Strange oil leak« on: June 16, 2016, 10:24:48 PM »
Cheers that's a spot on reply. Looks like it will be the 13 washers in that diagram. Any idea where to start my hunt? Cheers gordon
21
CB500/550 / Strange oil leak« on: June 16, 2016, 11:30:43 AM »
Hi guys I have a strange oil leak on my 76 550f, when the bike is run a small puddle of oil forms around the front left hand rocker cover bolt. Their are no signs of leaks anywhere on the head,barrel or rocker gaskets just by this one bolt. Any ideas? Cheers gordon
22
CB500/550 / Re: Bike won't start - help!« on: June 07, 2016, 04:20:05 PM »
Have you pulled the fuel filter from the tank and checked it.
23
CB500/550 / Re: Setting timing on a piranha ignition« on: April 24, 2016, 11:27:24 PM »
Cheers for the advice guys, will grab myself a strobe and give it a go.
24
CB500/550 / Re: Setting timing on a piranha ignition« on: April 24, 2016, 08:27:14 PM »
Cheers for the reply but that's what has me confused it's a light activated ignition from what I can gather so I can't use a strobe.
25
CB500/550 / Setting timing on a piranha ignition« on: April 24, 2016, 07:06:48 PM »
Does anyone know how you check/set the timing on a piranha electronic ignition. Tried looking everywhere for a manual but no luck. Cheers Gordon
26
Recommended Sources for Parts and Services / bike recovery/transportation bristol« on: April 27, 2015, 02:20:35 PM »
Used ace services bristol, when I needed my new project moving. Top notch service, prompt,well kitted van and reasonably priced. http://m.aceservicesbristol.com/About-Us.html
27
New Member Introductions / Re: hi from Bristol« on: April 21, 2015, 08:35:48 AM »
Cheers for the warm welcome guys,will try and get some pics up soon. Gordon
28
New Member Introductions / hi from Bristol« on: April 20, 2015, 12:06:32 PM »
Hi there guys just inherited a 76 cb550f which has been stored In my mates back room for ten years ish, I'm in the process of getting her running so bound to be asking some dumb questions on route. Cheers Gordon
Pages: 1 [2]
|