This section allows you to view all posts made by this member. Note that you can only see posts made in areas you currently have access to.
Messages - Safo
46
« on: December 30, 2018, 10:18:48 AM »
Would it do it only in 3rd and not in any other gear?
47
« on: December 30, 2018, 10:07:11 AM »
No Trigger it just felt like I wa pulling and releasing clutch very quickly
48
« on: December 29, 2018, 03:46:31 PM »
Sorry just noticed its no 4 on the list
49
« on: December 29, 2018, 03:38:20 PM »
We bought a full 500 set from classic gaskets Oxford
Any good?
50
« on: December 29, 2018, 02:55:22 PM »
And yes it has, top one is 2nd gear selected by turning drum by hand below is 3rd selected, it seems to be fully engaged but when the bike was last running it used to try jumping out of 3rd but never actually did so it was a case of short shift to 4th but it spoilt the ride, as I said before there is signs wear and evidence of the gears trying to separate but I still don't think it's excessive, should I turn my attention to the claw that pulls the drum around, is this a part that wears?
Thanks in advance
51
« on: December 29, 2018, 02:28:45 PM »
OK, if this has worked there should be 2 pics
52
« on: December 29, 2018, 12:51:57 PM »
Thanks everyone will try again
53
« on: December 28, 2018, 08:30:12 PM »
Yes I Already tried this, looks OK, also tried to Separate the gears by taking up all slack in selector mech but they still seemed to have purchess, just found 0.9mm end float in selector drum, selector fork measures 4.9 Grove in gear is 5.15 I think is OK what do you think? Tried to post pics but to big
54
« on: December 28, 2018, 06:14:26 PM »
Hi everyone
Some of will have seen my intro in newbie section.
The motor is now fully striped and I'm looking at the 3rd gear issue, which I now to be a problem the thing is there is signs of wear but not execesive, the forks look straight
Does anyone know how long the 3rd gear dogs should be should be
Thanks
55
« on: December 25, 2018, 09:55:29 AM »
Hi Trigger, the plan is to fix her issues and run her again, sticking front brake, warped f disc, fork gai tors split, seals leaking and overhall eng, fix 3rd gear
prob, replace broken pushrod and one new issue remove snapped m6 c/case bolt, thanks for throttle cable info hope that's why I joined
56
« on: December 25, 2018, 09:16:34 AM »
Thanks for the welcome everyone,
Here is a pic from a few yrs ago when we pulled her out for a dust down, well really a lot of elbow grease
57
« on: December 23, 2018, 10:37:28 PM »
Hellow sohc folks, firstly I must say that I do not directly own a sohc honda but my missus does, its a nice 500 four which she's had for many years and has been off road for many yrs, she won best jap
bike at Doncaster bike show in 1986, after years in storage and a little lack of care its time to get her back in decent running order again the( bike I mean,) so she is on the bench in bits for a re fresh
|
Show Posts