This section allows you to view all posts made by this member. Note that you can only see posts made in areas you currently have access to.
Messages - Deano400
Pages: 1 ... 3 4 [5] 6 7 ... 31
61
« on: September 11, 2023, 05:43:16 PM »
This is a good example. More often very difficult to see.
62
« on: September 11, 2023, 05:42:29 PM »
Like these markings in yellow Dom. Ignore the red marks.
[ Guests cannot view attachments ]
63
« on: September 10, 2023, 12:26:31 PM »
Nuts received. Many thanks Ken.
64
« on: September 03, 2023, 01:34:59 PM »
As far as I can remember early 400s had round end with tommy bar hole, my 75 has, later with hex head which my 78 has, according to my parts book the rear spindle changed at frame number 1065686 but no indication as to which spindle.
I have three front spindles, and all have the hole, the parts book doesn’t show that there was a change in front spindle.
All BZP.
65
« on: September 02, 2023, 04:19:46 PM »
Yes I'll take both Ken, thanks. Like you say I can cut the thicker one down to 10mm. I'll probaly clean them up and plate them anyway.
66
« on: September 02, 2023, 03:44:18 PM »
If you find a couple of nuts, PM me with the cost + P&P.
67
« on: September 02, 2023, 03:40:54 PM »
Yes I did get the breather clip off you. My memory is shocking.
68
« on: September 02, 2023, 03:33:47 PM »
I do have a CB200 as well. Don't remember you coming round. Having said that there's a lot I don't seem to remember now a days.
69
« on: September 02, 2023, 12:24:03 PM »
Hi Ken, very kind of you to offer to drop them off. However, I'm on the other side of Northwich from you, so I guess it would take about an hour diversion to drop them off on your way to Swettenham. If you do have two nuts, it would probably be best posted if that’s ok?
70
« on: September 01, 2023, 08:50:09 PM »
Thanks Athame. Can't do any lifting etc so may as well deal with the small stuff.
71
« on: September 01, 2023, 08:40:26 PM »
Hi Ken. Not going anywhere at the moment. Ended up in A&E, problem with my heart so grounded. Just pottering in my shed until I go back and find out what's going on.
72
« on: September 01, 2023, 07:56:58 PM »
Has anyone got the following that they feel they can part with?
94001-12200 Hex nut 12mm with 17mm head x 2
They are for the rear lower engine mounting bolt, the one the front footrest mounts onto.
73
« on: August 27, 2023, 09:55:17 PM »
74
« on: August 18, 2023, 03:01:57 PM »
Agree, it most probably is an after market part. The PO has put the connector in there as the after market part meant the connectors were male to male and female to female. Not the way I would have done it but was the easiest way to get round the problem.
75
« on: August 14, 2023, 01:00:36 PM »
As Graham says:
[ Guests cannot view attachments ]
Pages: 1 ... 3 4 [5] 6 7 ... 31
|
Show Posts