Honda-SOHC
SOHC.co.uk Forums => CB500/550 => Topic started by: DomP on April 27, 2024, 02:57:12 PM
-
https://www.ebay.co.uk/itm/204061144662?mkcid=16&mkevt=1&mkrid=711-127632-2357-0&ssspo=-JvW0lVRTvK&sssrc=4429486&ssuid=Y0YDXM_4R0-&var=&widget_ver=artemis&media=COPY
Whats the chances this fits a cb550?
-
Extremely doubtful
Sent from my SM-A546E using Tapatalk
-
Extremely doubtful
Sent from my SM-A546E using Tapatalk
I'm ever the optimist!
-
Couldn't you cut a piece of 6mm alloy to shape, drill for the screw,
Make a gasket, and fit??
Or you could buy a sheet of carbon fibre, the sort that is used for models,
Sent from my SM-A546E using Tapatalk
-
Couldn't you cut a piece of 6mm alloy to shape, drill for the screw,
Make a gasket, and fit??
Or you could buy a sheet of carbon fibre, the sort that is used for models,
Sent from my SM-A546E using Tapatalk
I thought it might need an insert with an oring to seal but you are probably right, certainly worth trying
-
Just leave the cable off but fit the drive housing, there is an oil seal in there
-
Just leave the cable off but fit the drive housing, there is an oil seal in there
Good point Bryan!
-
With the drive gear of course!
-
I don’t understand the sizing of that so don’t really know Dom, somebody with far superior marbles will probably be along shortly to tell you. It’s a bit dear at nearly 30 quid though.
This is similar to what I used and it’s a dead tight fit so not coming out, think I had to tap it in with a block of wood to get it in right but fits a treat for less than 10 bob(https://uploads.tapatalk-cdn.com/20240427/15059f4d5cfec1a3c4a0693ff73e932d.jpg)
Sent from my iPhone using Tapatalk