This section allows you to view all posts made by this member. Note that you can only see posts made in areas you currently have access to.
Messages - hondatri
76
« on: April 02, 2014, 06:52:32 PM »
Thanks Guys for suggestions I will get back to engine tomorrow and try your suggestions.
77
« on: April 01, 2014, 07:14:20 PM »
Well guys thanks for replies I have sourced the Rings at Gardenhire and supplies.Now for the Stupid part I did not mark the piston on removal and dont know which way round it goes and there is no arrow on top.The piston Skirt is shorter on one side and would like to know does it go to inlet or exhaust, I am not familiar with smpkers
78
« on: April 01, 2014, 07:07:37 PM »
Thanksto all who replied and offered advice and suggestions. I have replaced the Stator and Regulator and all is now fine and charging is back to normal. I sourced the parts on E bay from Zoom Zoom in US and their service was excellent and the price good.
79
« on: March 25, 2014, 02:26:42 PM »
Thanks Guys. I have been advised to do away with the connectors and solder the wires in position. What do you think?
80
« on: March 24, 2014, 08:01:04 PM »
I am trying to help an elderly neighbour get his cyclemotor going again. It is a Bernardi engine that bolts onto bicycle driving the back wheel. It was not pulling so he asked me as I have bikes to have a look at it. I found the two piston rings broken and Have been looking for 2 or for a piston and rings. The Piston Dia is 34mm. The Engine is a BERNARDI made in Italy European Patent 82830113 5.
I would appreciate any help in locating parts. I would like to get the Old Boy Mobile again as I miss seeing him potter around on it. You were likely to see him anywhere on it
81
« on: March 24, 2014, 07:45:24 PM »
Hi guys my Sons Blade has blown its Voltage Reg. I have a new one but the 2way connector on bike loom into which Reg DC output connector is connected is Burnt and I would like to replace it. But honda agents say I must buy the loom expensive, The connector is an 8.25 connector anyone know where I can get one.
82
« on: January 22, 2014, 06:38:19 PM »
Thanks Guys for info Now to get the box out on Kitchen table.(When wife out)
83
« on: January 21, 2014, 06:38:03 PM »
Hi from a newbie I have been given a box of Genuine Honda parts in original packaging I was told they for 400/4 or CB750 Is there any place where I can Check the Part numbers to see what they are and for which bike Some are bushings and some are seals.
|
Show Posts