Honda-SOHC
SOHC.co.uk Forums => CB750 => Topic started by: philward on December 14, 2016, 05:56:55 PM
-
Hi All - has anybody got a set of engine mounting plates/brackets they can sell me - engine will be going back in in the New Year
Thanks
Phil
-
I'm struggling to get hold of these 2 plates and DK want 40 squid because they won't split them from the rusty engine bolts (I've bought a set of stainless of bolt off Trigg so don't need them)
I might as well make a set up but to save me stripping them from my standard k2, has anybody got a set off the bike that they could make cardboard templates from for me?
Thanks
Phil
-
I will have a look tomorrow Phil.
-
Thanks Graham
-
Are these the ones you want a template of ?
I can match the front one but can't match the rear, as everything I have has the oil tank in the way.
-
Just seen this Phil......if you want to pop over to Lytham St Annes you can borrow mine to use as templates. My K4 is (still) in bits..........I could take some dimensions and photos for you but it's probably better if you just took the plates and made some up.
I'm not in any rush to get mine back as long as its weeks rather than months.
Please PM me for more details.
-
There the ones Graham - if you can't easily sort a template, I'll take up MCTID (sorry, i don't know your name) up on his offer and try to get up there over the next few weeks.
MCTID - If Graham can't sort a templates, I'll PM you over the next few weeks - your about 45 miles away - as I am away over Christmas
Thanks to both - much appreciated.
Phil
-
There the ones Graham - if you can't easily sort a template, I'll take up MCTID (sorry, i don't know your name) up on his offer and try to get up there over the next few weeks.
MCTID - If Graham can't sort a templates, I'll PM you over the next few weeks - your about 45 miles away - as I am away over Christmas
Thanks to both - much appreciated.
Phil
I can draw round them is two minutes, quicker than driving 45 miles ;D
PM me you address Phil if you like me to do some drawing.
-
I've PM'ed you Graham - thanks
MCTID - Thanks also for your offer
Thanks
Phil
-
All drawn up Phil, will pop it in the post to you. You will require 4mm plate to make these up.
-
Thanks Graham
-
Just got the templates - thanks again Graham