Honda-SOHC
SOHC.co.uk Forums => CB500/550 => Topic started by: sye on February 24, 2019, 09:32:23 AM
-
After fitting the replacement coils i have a piece left over from the parts box. It's No19 on the image and looks as if it attaches to a bracket but I can't remember where and it's not clear on the parts list. Any ideas welcome.
-
Funny, I was looking at that same picture a few days ago. Also I wondered what it was for and if I had ever seen it on my bike. BTW, I was there to fasten a loosened bolt, the one for the fat green ground wire. Now I know where it is. You have got it. >:( Anyway, maybe somebody can post a pic of how it is supposed to be mounted.
-
Dont ask me, got lots of 500 projects and no idea on that one! Who bought the green K0 from James? Can they have a look?
-
One of your HT leads (probably number 4) is supposed to be supported by that bracket to protect it from something or other. What's your HT lead laying close to, probably a heat source.
-
Its actually a very thin curved channel that looks as if it's there to protect a single wire cable, just one as it's probably only 2mm or so wide. It's not obvious where it goes but it was attached to the forward coil bracket mounting bolt, so probably goes there somewhere. The most logical explanation is to protect the green earth wire but I can't be certain? Should have taken a picture...
-
Why is it always the one thing you didn't take a picture of. Good luck with it somebody will know.
-
I think it goes at the front of the coils and curves round undervthevframe with a bolt through it , if its the piece I'm thinking of , will try post a pic
-
is this it
-
That's it, Dave, you are a star, than you so much, off to fit it (in the right place) now. ;D
-
No worries mate , thats why i love this forum 8)