Honda-SOHC
SOHC.co.uk Forums => CB500/550 => Topic started by: thomaspigeon on May 05, 2021, 09:34:41 AM
-
Hello everyone,
It seems like finding the usual boot plug for the intake manifold is nearly impossible unless someone is ready to wait for a month or two. What you guys are using to block the plug without risking a leak?
Thanks a lot
Tom
-
Butt plug?.Oops,wrong forum :'(
-
Haha, I can’t find the real part name but this
https://www.ebay.co.uk/itm/223817430995 (https://www.ebay.co.uk/itm/223817430995)
-
Haha, I can’t find the real part name but this
https://www.ebay.co.uk/itm/223817430995 (https://www.ebay.co.uk/itm/223817430995)
Ooooh, don't think I've ever seen them on a Honda CB SOHC/4 🤔🤔🤔🤔
-
Never fitted to sohc4, they all have screws with soft washers
-
Seen them on bikes I had in the 70's - so Z1 or GS range?
-
Z650 has them :D
-
Hey everyone. As odd as it sounds it’s a CB550J3 with F1 carbs. Please find the photo below. Also my idling is hanging when hot for a few seconds. I don’t know if that’s linked. But I struggle to get it running smooth.
-
And those jubilee clips are too wide so will cause air leaks
-
Nicely spotted Brian, it’s hard to find the right jubilee clip size so feel free to send me a link. Thanks
-
I bought some of these from ebay, item no 402702096350
Price gone up since i got mine and still a fraction big but a lot better.
Cany seem to get my dumfone to copy links but then its still to smart for me, i still get problems with 2 cans and string!!
-
Haha No problem Bryan, I found it. It’ll take a month to arrive though. Do you know the bandwidth of yours?
I found some 9mm (which is 3mm less than mine), is it narrow enough?
Also I found some cb550 inlet manifold in Germany for £40, worse the shot? I guess I’ll have to change the O-ring straight away. Find the links below. Cheers
https://www.ebay.co.uk/itm/253627467056 (https://www.ebay.co.uk/itm/253627467056)
https://www.ebay.co.uk/itm/373513175775 (https://www.ebay.co.uk/itm/373513175775)
-
O rings are same as tappet caps so readily available, if the rubbers are soft enough to use those are wrth a shot i will measure the clips i got seem to remember 8 or 9mm, you will need to cut off lots of extra when you put them on
-
if you have not ordered the maniolds i have a pair of the correct ones, £25 pair plus post
-
@oddjob, jubilee clips ordered. A bit expensive but if that does the job I’ll be happy. Thanks for the tip.
-
if you have not ordered the maniolds i have a pair of the correct ones, £25 pair plus post
I have PM’d you about it. Thanks
-
hi Tom no message received yet
-
I just sent you one now. I’m not really good with that technology ::)