Honda-SOHC
SOHC.co.uk Forums => CB650 => Topic started by: judodave on December 18, 2010, 02:09:28 PM
-
Hi,
I've just managed to get an original grab rail for my CB650z but it looks like I need some inserts for the bolts that go through the rail and frame and into the mudguard.
If somebody has the same bike, could you let know what they look like as there seems to be a gap of at least an inch either side.
regards
Dave
-
Is this any help?:
http://www.cmsnl.com/honda-cb650-80-us_model7223/partslist/ (http://www.cmsnl.com/honda-cb650-80-us_model7223/partslist/)
The rear fender diagram shows the grab rail as having "built-in" spacers. Although it's not a Z model....you can search for other models in there.
-
Hi Dave let me know what the size is or a drawing as there was a load of spacers in the box of bits and they mite with any luck i might still have them, i sorted a lot out and stored them in my box of spare spacer,s that i have.
Paul
-
Thanks Paul,
My bike is at a Mate,s garage at the moment, when I get up there I will have a look and come back to you. I made the mistake of drilling out the thread inside the mudguard to put some LED indicators in the position where the bolt goes through to secure the grab rail. This is before I got the grab rail as it was taking so much time to locate one. I have the original indicators which I will put on the back and front. The honda manual does show some kind of spacer but its hard to work out what it is. regards Dave