Honda-SOHC

SOHC.co.uk Forums => CB350/400 => Topic started by: Greg65 on June 14, 2014, 08:06:05 PM

Title: Exhaust split collars
Post by: Greg65 on June 14, 2014, 08:06:05 PM
Hi guys.

I am about to get my first 400 next week. Now it needs a new exhaust system as the collector box is shot and it has an odd silencer and poor chrome on the down pipes. So I was intending to put a full replacement in from the Silver guys. Now my question is should the split collars be replaced as well or are they subject to condition? I will post pictures once I get the bike but it's a very low mileage model from Holland so need to get an MOT before I can register it. Thanks.
Title: Re: Exhaust split collars
Post by: Norniron on June 14, 2014, 09:06:47 PM
It depends greg whether its a show bike or a daily/once a week hack.they are quite expensive,so if it was me id clean the rust off and spray them up with some vht silver spray
Title: Re: Exhaust split collars
Post by: Greg65 on June 14, 2014, 10:01:08 PM
I am not talking about the finned clamps at £25+ vat each! but the split collar pairs at £7.50 that go around the pipes before the finned collar clamps them along with the gasket.
Title: Re: Exhaust split collars
Post by: Bryanj on June 14, 2014, 10:04:20 PM
Only replace if knackerd
Title: Re: Exhaust split collars
Post by: Greg65 on June 14, 2014, 10:16:34 PM
Thanks for the info guys. I found a good thread on the state side forum which answered all and more, must remember to check it next time, cheers.
Title: Re: Exhaust split collars
Post by: Lobo on June 15, 2014, 01:31:49 AM
Greg... don't know what your alternative forum had to say....  but if you do decide to re-new the set, beware. 

I ordered a new set of these from DSS and they were about 10mm too long.... meaning I couldn't get enough thread from the studs to tighten down the finned collars.  Ie the hack saw had to come out onto the new split collars.

Cheers,
Simon.
Title: Re: Exhaust split collars
Post by: Greg65 on June 15, 2014, 06:11:07 AM
Thanks Lobo. As I was putting in a new exhaust I was inclined  to replace them, however as their job is to transfer the pressure from the finned clamps to the exhaust flange ensuring the new gasket seals. I think I will wait and see what condition the old ones are in.
Title: Re: Exhaust split collars
Post by: ka-ja on June 15, 2014, 09:23:25 AM
Hi,
    Had mine coated with industrial chrome plating, fairly cheap and looks like cadnium plate----ken
Title: Re: Exhaust split collars
Post by: steven400/4 on June 15, 2014, 03:26:56 PM
make sure you dont get the big one,s [10mm] to long when you order them as for the u s ones they are smaller and no need to cut them down plus if you look at the parts number in the book there is to numbers one number for big set one number is for the small set  ;) ;) ;)
SimplePortal 2.3.5 © 2008-2012, SimplePortal