Show Posts

This section allows you to view all posts made by this member. Note that you can only see posts made in areas you currently have access to.


Messages - wrighty

Pages: [1]
1
New Member Introductions / Re: new member with a cb125s
« on: June 21, 2016, 07:58:21 AM »
Quote from: Bryanj on June 21, 2016, 05:41:41 AM
All honda points are set at 0.35mm or 14 thou when on the top of the cam and should open as the "F" mark on the alternator lines up with the static mark on the case, if a battery ignition best way to tell this is with a bulb connected accross the points spring and ground so the
 bulb lights up as the points open, if not battery use a multimeter to measure resistance which goes infinite as the points open

Thanks for the advice....

1 question does the points plate have to be moved to a specific place or lined up anywhere

Thanks

2
New Member Introductions / new member with a cb125s
« on: June 20, 2016, 08:51:25 PM »
Hi everyone I'm mark from a little village called edwinstowe in Nottinghamshire. I purchased a complete basket case up in April this year as I'm a big fan of hondas having had quite a few in the past. This bike was in a complete bad state but mainly just surface rust. The bike came with plenty of spares so I had lots of salvagable parts. The engine though was seized so it was completely striped and fully rebuilt with new crank and 190cc oversize kit.....


This is the bike when I collected it



And then at home in my shed





Few spares







Ok how it looks now...minus exhaust and drive chain









190cc cylinder left....125cc cylinder to right




If anyone could give me advice about setting points and ignition timing I'd be most grateful...

Thanks

Pages: [1]
SimplePortal 2.3.5 © 2008-2012, SimplePortal