This section allows you to view all posts made by this member. Note that you can only see posts made in areas you currently have access to.
Messages - Dave B
1
« on: April 10, 2021, 05:04:13 PM »
Thank you
2
« on: April 10, 2021, 03:37:39 PM »
Hi just getting to the end of rebuilding 1975 CB750FO
Any advise on which tyres to fit
Cheers
Dave
3
« on: February 15, 2021, 07:01:00 PM »
one little weak cough
then nothing
4
« on: February 15, 2021, 04:19:18 PM »
OK,
Some progress .
Carbs cleared again and reinstalled.Still won't start.
Used Easy start spray.Still no go.
The plugs are wet and good spark.
However i have just checked the points.
One side is intermittently sparking the other set not at all.
Do i need to fit new points and condensers?
Cheers,
Dave
5
« on: February 14, 2021, 07:19:44 PM »
Yes they were solid as were the main jets and idea jets.
Just a thought, is there any jet holes in the brass fitting above the main jet that houses the needle
Dave
6
« on: February 14, 2021, 07:06:54 PM »
Thats true,
They are sinked when connected
7
« on: February 14, 2021, 04:36:50 PM »
Thank you i will let you know
8
« on: February 14, 2021, 04:19:28 PM »
I will get some easy start ordered
Thank you
9
« on: February 14, 2021, 04:11:55 PM »
Yes main jet tubes are clear Air Filter and box in place Choke on
10
« on: February 14, 2021, 03:43:30 PM »
I have got to the stage of trying to start my bike which came as a box of bits. IT won't start.
Carb jets were all very blocked.Slides seized.
I have cleaned the carbs and all jets are clear and slides and needles running free.
All four float bowls are filling with fuel but fuel does not appear to be passing through jets around the needles.
I have a good spark and good compression.
I have attached a picture of two tubes that i believe just vent atmosphere.
However when i apply compressed air to open tube end it will not pass through to inside of carb.
The tubes are new.
I have twice stripped the carbs and checked jets and floats.
Any ideas greatly appreciated,
Dave.
11
« on: February 06, 2021, 02:59:08 PM »
Thanks for all the input.
The prices are crazy for the right one.
I have spent the morning adapting a Harley silencer to fit.
So ill see how that works!
Cheers,
Dave.
12
« on: February 05, 2021, 06:54:32 PM »
Hi,
Has anybody got any idea where i can find a silencer for my 4 into 1 exhaust system
that is legal.
13
« on: February 01, 2021, 10:47:53 AM »
Thats confirmed
Thank you
cheers dave
14
« on: January 31, 2021, 08:11:22 PM »
Brilliant
Thank you
15
« on: January 31, 2021, 04:52:23 PM »
SO,
Black and blue wire from run switch is the live feed
Black with white wire goes to coils.
All now working.
Tomorrow i start on the new lefthand switch!
Thanks for your help
Cheers,
Dave
|
Show Posts