This section allows you to view all posts made by this member. Note that you can only see posts made in areas you currently have access to.
Messages - Pauarc
Pages: 1 ... 6 7 [8] 9 10 ... 15
106
« on: August 14, 2023, 04:41:43 PM »
I used a dishwasher tablet in a ultrasound bath they came out pretty clean
107
« on: August 14, 2023, 01:12:21 PM »
When out today the bike running the best it has done
Setting on carb are 110 main 40 slow 1 turn air screws, needle slot on 3
Hm341 exhaust, carbs are 657b, Dynas ds1-2kit electric ignition, standard coils
D8EA plugs and sync with carbtune pro,will check the plugs after a good run
thanks for all your help
108
« on: August 09, 2023, 07:27:40 PM »
Which dense plug fit in place of the ngk
109
« on: August 09, 2023, 09:26:07 AM »
I think I will change it to slot 3 and I think this should put carb back to standard fingers crossed
110
« on: August 08, 2023, 07:49:58 PM »
Would this make it run rich what do you set them at
111
« on: August 08, 2023, 01:47:38 PM »
Striped carbs needles are 27201 they are on slot 4 from the top
112
« on: August 07, 2023, 04:44:16 PM »
It idle better about 1turn and rev up ok and good response up to 65 to 70 from stand still. It just the tic over I would like to get better
113
« on: August 07, 2023, 10:42:10 AM »
How the plug’s looks now
114
« on: August 07, 2023, 09:02:10 AM »
All air screws are working correctly all set to best tick over
115
« on: August 07, 2023, 08:55:49 AM »
All plugs are now running a bit on rich side
116
« on: August 06, 2023, 09:39:14 PM »
110 jets in Been for run for about 30 miles runs ok tick over a little rough air screws now 1 turn out. was 1 and half going to look at plugs tomorrow morning
117
« on: August 06, 2023, 10:07:36 AM »
Got key out kept banging on wooden bench just got to put back on bike
118
« on: August 04, 2023, 06:44:48 PM »
I will have a go in morning thanks hope it works
119
« on: August 04, 2023, 06:32:02 PM »
How do you take them apart I have a couple of spare keys I would like to keep all locks the same have got lock off tried banging on rubber mate
120
« on: August 04, 2023, 06:11:18 PM »
Is it possible to take IGNITION SWITCH apart key broken in lock
Pages: 1 ... 6 7 [8] 9 10 ... 15
|
Show Posts