This section allows you to view all posts made by this member. Note that you can only see posts made in areas you currently have access to.
Messages - Tiny Tim
16
« on: September 26, 2015, 07:09:56 PM »
Cheers Mike.
17
« on: September 26, 2015, 07:08:54 PM »
18
« on: September 26, 2015, 07:07:29 PM »
That would explain a few things then. Back to the telephone then.
19
« on: September 26, 2015, 07:01:05 PM »
Right next stupid question.
At some point in its life my 400 has had the cam chain adjuster bolt located at the front of the engine replaced with a none standard part. I now have the right bolt, washer, o ring & nut to replace the crap one.
What I can't figure out is, can I just remove the offending item and fit the new one or is it more involved.
Cheers
Tim
20
« on: September 26, 2015, 06:50:24 PM »
I agree with the naming and shaming policy.
Especially if his bike was to turn up on fleabay, I'll be more than happy to throw in some bids then withdraw them just to wind him up.
21
« on: September 26, 2015, 06:45:28 PM »
Hi guys.
Started to check the valve clearances the 400 this afternoon and all was going well until I got to no3 intake valve. Whilst trying to adjust it I noticed that the feeler gauge will not pass under the rocker arm as it is tight up against the top of the spring. It loosens off when the engine is rotated to adjust the other valves.
I've followed the manual to the letter checking and re-checking and it still arrives back at the same place.
Cheers
Tim
22
« on: September 26, 2015, 02:05:23 PM »
When will my chroming be ready? 
23
« on: September 21, 2015, 07:48:21 PM »
Bike looks very good so far Roy.
I'm still waiting for stuff to come back from the chromers, painter has all the tins etc.
It's all at a stand still at the moment.
24
« on: September 19, 2015, 09:01:28 PM »
Glad the website worked out for you Mike
25
« on: September 17, 2015, 08:06:39 PM »
Utter madness
26
« on: September 17, 2015, 08:02:06 PM »
Right then, time for an update.
Tins were dropped off to the painters today.
I've been assured by the chromers I'll get my stuff back end of the month.
Should be taking the engine over to a mechanic friend of mine in a couple of weeks to strip and rebuild. His help has been invaluable over the past couple of months.
I'll sort out some more pictures this weekend.
Getting there slowly and when funds allow.
27
« on: September 17, 2015, 07:53:22 PM »
Wow! That's a wonderful collection you have.
28
« on: September 16, 2015, 08:31:24 PM »
How much do you think I could get for a genuine sand castle 
29
« on: September 16, 2015, 08:29:31 PM »
Nice looking bike
30
« on: September 16, 2015, 08:27:48 PM »
|
Show Posts