This section allows you to view all posts made by this member. Note that you can only see posts made in areas you currently have access to.
Messages - Glynnrg
16
« on: May 21, 2017, 07:42:16 AM »
why cb550f1 the third exhaust not getting hot I presume this cylinder isn't running properly plug seems to be getting wet when I pull plug cap of engine dies slightly tho sparks on all plugs don't seem that bright but not knowing what they should look like don't if this is normal Anyone got any ideas
Thanks
17
« on: January 06, 2017, 03:03:08 PM »
thanx paul
18
« on: January 02, 2017, 11:52:49 AM »
Am I looking into this tooo deep I have tried the autosol remedy put fuel through the carbs bearing in mind I am doing this on the bench if I turn the petrol tap I don't seem to get fuel out the overflow unless I give them a fist full of throttle then only one them leaks out of the overflow ??
19
« on: December 31, 2016, 04:53:40 PM »
Thanx I'll give it a go
20
« on: December 31, 2016, 09:37:48 AM »
Morning to all
I have removed the carbs and cleaned fitted rebuild kit the rebuild kit came with 3 small rubber o rings not sure where they went and looking at other rebuild kits u could get they wernt always included (so didn't fit them)
Before I fitted them back on the bike I put petrol through them on the bench one of the carbs is still leaking via the overflow is this the norm or have I still got a problem
Any ideas what could be causing this and any solutions
Ps the floats don't seem to be sticking
Many thanks and a happy new year
21
« on: April 30, 2016, 03:06:01 PM »
Where did Stella get in to this I'm interested in the cider Brewers on here that want to send me some samples lol
22
« on: April 30, 2016, 12:37:15 PM »
Send a few bottles over to Essex I'll tell you who's best at brewing lol
23
« on: April 29, 2016, 10:41:03 PM »
But best for lubricating the throat lol
24
« on: April 29, 2016, 05:17:44 PM »
Don't waste good cider on the bike get it down your neck
25
« on: April 28, 2016, 09:02:56 PM »
Not sure what's in it but saved a strip down of the carbs for now
26
« on: April 28, 2016, 08:43:24 PM »
Before redex sticking floats leaky carbs unable to idle below 1400rpm
After redex no sticking floats no leaky carbs ticking over lovely
well worth the 6 quid!!
27
« on: April 12, 2016, 08:47:09 PM »
Are the switches with just the horn USA spec?
28
« on: April 12, 2016, 08:32:35 PM »
Tell me if I'm draft but does anyone use redex in there bike?
29
« on: April 12, 2016, 06:30:22 PM »
I have got a passing light integrated on the horn switch of my 550f1 is this correct for this model?
30
« on: April 12, 2016, 06:27:02 PM »
Just found a very very small weep at the master cylinder piston looks like a rebuild kit is needed
|
Show Posts