This section allows you to view all posts made by this member. Note that you can only see posts made in areas you currently have access to.
Messages - Pauarc
Pages: 1 ... 9 10 [11] 12 13 ... 15
151
« on: July 03, 2023, 07:12:20 PM »
Pic from manual
152
« on: July 03, 2023, 06:59:17 PM »
I am trying to work out where on the shaft that is have I got to remove central shaft where the basket sits on?
153
« on: July 03, 2023, 01:55:50 PM »
I have removed clutch today before I undone central bolts there was slight in and out movement so took out plate stack which 36.5mm in total also springs out 35.5 long most have noted down wrong so in front of basket the spiled washer I can’t find a thing washer where should it be I have put back together maybe a little better no free play in central nut just to try
154
« on: July 01, 2023, 11:30:18 AM »
Now I have decided that I’m going to remove clutch and see if I can find something I will see if there’s any end float
155
« on: July 01, 2023, 08:58:57 AM »
Just when for a test run to try clutch adjustment a bit better cold but worse when hot 🥵 could it be the oil getting to sticky when hot in the 70s I used 20/50? Any thoughts it has putoline s4 mineral oil 10w40 in now
156
« on: June 30, 2023, 07:50:46 PM »
When you fit keyed washer should it have be loose on shaft I have douts the fin washer was there I think I am going to take the clutch out to find out if it’s there
157
« on: June 30, 2023, 04:57:55 PM »
If the fin washer is missing behind basket could this effect the clutch I can’t remember seeing it
158
« on: June 30, 2023, 09:58:58 AM »
I have just set central nut as you suggested have not tried yet as out today
159
« on: June 30, 2023, 07:56:11 AM »
The clutch drag a bit before and gear change was clunky old plates were hard not any better with new plates no thin washer that I can remember but there was a thick washer
160
« on: June 29, 2023, 09:01:02 PM »
I just checked the old ones they are 31.5 mm the new ones are 31.9mm I made a note and yes flat side in and bevelled side out.
this is the length off springs in the manual I have
161
« on: June 29, 2023, 08:12:43 PM »
Before I fitted new plates I put the steel plates in a ultrasonic cleaner springs are new
162
« on: June 29, 2023, 07:44:12 PM »
This was before I fitted new chork plates
163
« on: June 29, 2023, 07:39:58 PM »
My bike is a Honda CB750k2 1975 all straight plates
164
« on: June 29, 2023, 06:51:07 PM »
I have no double steel plate what would this do
165
« on: June 29, 2023, 12:38:55 PM »
Just a thought could it be the oil any suggestions on that
Pages: 1 ... 9 10 [11] 12 13 ... 15
|
Show Posts