This section allows you to view all posts made by this member. Note that you can only see posts made in areas you currently have access to.
Messages - billy192
Pages: 1 ... 10 11 [12] 13 14 ... 21
166
« on: January 19, 2014, 04:21:14 PM »
I haven't tightened up any of the fork bolts yet but good spot and yes all new spring and bolt for the adjuster.
Billy
168
« on: January 19, 2014, 02:40:11 PM »
Just putting my front wheel on it lookis as if the disc is a bit close to the stanchion.  or is this OK?  it all bolted up ok. Am i missing something? Billy
169
« on: January 15, 2014, 05:00:22 PM »
well after 48 hrs it looks like its breaking down. now to make a jig to turn it slowly with some nuts and bolts to make a first class job  Billy
170
« on: January 13, 2014, 04:29:49 PM »
RGP750,
i have sealed my other 3 bikes with POR 50 and after 3 years they are holding great happy just to get this crud out.
Ken,
yes my heavy duty gloves and respirator will be on. i will let you know how it fairs
Thanks
Billy
171
« on: January 12, 2014, 05:09:28 PM »
so far I have tried petrol and then Acetone noting. i would leave with just petrol and use but the liner is about 1 inch thick at the bottom and it keeps stopping the fuel exiting. i have ordered some MEK (read on the other forum this will shift anyrhing) fingers crossed. so far spent £60 may have got another tank for that  Billy
172
« on: December 31, 2013, 03:28:58 PM »
Just picked up a tank and has been lined with what looks like resin. how can i strip this out please?
Billy
173
« on: December 26, 2013, 09:20:51 PM »
My first batch  Billy
174
« on: December 26, 2013, 09:02:23 PM »
Thanks
Lobo
175
« on: December 25, 2013, 07:06:02 PM »
great thanks
Billy
176
« on: December 25, 2013, 11:20:06 AM »
merry christmas
just fitting the loom on my 750 k6 and not sure, but does the loom route through the triangle under the tank or run by on the side rail?
thanks
Billy
177
« on: December 21, 2013, 09:26:51 PM »
ok so i think i have done it i think  i had to dremel the bottom of the fork ears as they had built them up with copper and chrome  then they went up over the base OK but it was tight Billy
178
« on: December 15, 2013, 07:54:40 PM »
Thanks for the pics
179
« on: December 15, 2013, 05:39:26 PM »
they fit in the top of the ears between the top tree,
Billy
180
« on: December 15, 2013, 05:06:58 PM »
great Steff750
but my collars won't go over the shrouds, they have been re chromed and they did them twice. perhaps i need to dremel them slightly so they do fit over the shrouds,
ps just done the carb rubbers see what you mean LOL
Billy
Pages: 1 ... 10 11 [12] 13 14 ... 21
|
Show Posts
