This section allows you to view all posts made by this member. Note that you can only see posts made in areas you currently have access to.
Messages - Dave M
Pages: 1 ... 18 19 [20] 21 22 23
286
« on: September 22, 2007, 08:05:28 AM »
This weekend is the Southport Air Show and the weather for today looks excellent (unlike tomorrow!).
I'm going to go on my bike so there'll be no worries parking.
Anyone else going?
287
« on: September 21, 2007, 07:37:30 AM »
Nor me!
288
« on: September 19, 2007, 07:46:29 AM »
Air leak or mixture screw sounds good especially if the bike's been stood with fuel in the carbs for a while.
289
« on: September 17, 2007, 08:00:32 AM »
I wonder why that is Dave...
290
« on: September 06, 2007, 09:38:45 PM »
I've had all the air screws out and given them a good clean and made sure they're all seating properly and am now running at 2 3/4 turns out which is + 1 turn on what Mr Haynes says.
It's running really well now with a very slight hesitation when opening up at around 4k revs in a high gear. However I'm happy and can live with that.
Just need to tweak the balance now.
I've done nearly 500 miles now and overall I'm very happy with the way it runs!
291
« on: September 06, 2007, 09:34:46 PM »
I'm still looking but I might know where there is one on a 550K3.
It would appear that the K3 wheel will fit mine so I'll give him a call when I get back.
292
« on: September 06, 2007, 01:37:38 PM »
Just heard that Southport was heaving with bikes last night so it seems business as usual at the moment.
293
« on: September 06, 2007, 01:36:35 PM »
Thanks Steve.
294
« on: September 05, 2007, 09:36:49 PM »
Hi again.
Does anybody know if the rear wheel on a CB550K3 is the same as the one on a CB550F2?
I've checked some parts lists for the K1 and the rim and hub part numbers are the same so I was wondering if the K3 was the same as well as I may have located a wheel.
Thanks,
Dave
295
« on: September 05, 2007, 07:20:13 PM »
I will.
296
« on: September 05, 2007, 07:19:40 PM »
That's right Steve.
A good quality copper cored lead with an NKG 5k resistor plug cap will do the job admirably!
297
« on: September 05, 2007, 05:24:21 PM »
All may not be dead at Southport.
Apparently the cafe owner has coned an area off for the bikes and put up some pretty posters to look at.
Not sure how the ccess is yet, I'll have a look after my hols.
298
« on: September 05, 2007, 05:22:42 PM »
They also act as a suppressor to reduce interference on radios etc.
299
« on: September 02, 2007, 06:10:19 PM »
Use a lower gear. Sounds nice too!
300
« on: September 01, 2007, 06:55:03 PM »
Sounds like a good plan.
Pages: 1 ... 18 19 [20] 21 22 23
|
Show Posts