Show Posts

This section allows you to view all posts made by this member. Note that you can only see posts made in areas you currently have access to.

Messages - westfieldandy

Pages: 1 2 [3]

CB750 / Re: 750 gearbox bearings

« on: June 12, 2011, 06:23:34 PM »

Hi everyone,

Thanks for your reply's it looks like i will have to try honda for bearings. or get grooves machined.

steve, i remember you from north weald, I will try and post some pics, unfortunately the seeley blew its engine up and i have not had time to put right, however, i managed a first place with it at thundersprint, and i took it to reims, and zolder for some demonstration events. The engine ran very hot at reims and i reckon the oil became too thin and pressure went and some damage has occured. not sure how bad as i have not stripped the engine yet.

i will post pics in the appropriate place

andy

CB750 / 750 gearbox bearings

« on: May 19, 2011, 06:02:32 PM »

Hi everyone

i just collected a set of bearings to rebuild my gearbox with, but the ones with the circlip groove have a narrower groove in them than the old ones, they have also come with a full circlip rather than a half one, this means the bearing could move in housing does'nt it, where should i order my bearings from to get the right ones.

andy

seeley
cr
britain
f2
f2
k7

CB750 / f2 jumps out of 5th

« on: August 26, 2009, 06:16:38 PM »

my f2 jumps out of 5th, any idea's, can i lift bottom engine casing off leaving crank and everything in top half, so i can check transmission?