This section allows you to view all posts made by this member. Note that you can only see posts made in areas you currently have access to.
Messages - Piki
Pages: 1 ... 20 21 [22] 23 24
316
« on: August 30, 2013, 01:10:16 PM »
Is a Post called HONDA FOUR SERVICE in MISC/OPEN.
317
« on: August 30, 2013, 10:19:15 AM »
Yes, I just upload one PDF about it, look my last post!!!
Sorry for my English.
319
« on: August 30, 2013, 08:49:39 AM »
STROBE is good for checking the advance and for "FIRE TIME" adjust, you can do both, "Timming and Advance".
Best Regards.
320
« on: August 25, 2013, 10:58:47 AM »
Ufff here in Spain, 1000 euros is a "good price" for that bike. Here the Japans bike are very expensive, the rest of EU is other history 
321
« on: August 22, 2013, 11:49:00 PM »
My cover is not original but looks great, look:  
322
« on: August 22, 2013, 12:56:33 PM »
In this moment I have a Giuliari seat on my bike, but it is bad for two people  , CB550 k3 Seat is big and I do not like much, I had one but sold it on Ebay  . I would like fit some seat good for two people but that looks great!!! Thank you for your answer.
323
« on: August 22, 2013, 08:39:01 AM »
Hello all,
Can I use the seat from Hond CB500 Four in my CB550 K3?
Thank you.
324
« on: August 21, 2013, 09:40:38 AM »
Take off all rubber parts!!!
325
« on: August 10, 2013, 03:26:59 PM »
Thank you Oddjob that is a good idea!! Sorry but I don not speak English and is possible that I do not understand well.... I will buy one new points plate, fit it on my bike, then I connect my Original Honda Dwell and measure the Grade Dwell, that is the correct measure, not??
Points Original or After Market??
Thanks and sorry for my English..
.
326
« on: August 09, 2013, 08:47:02 AM »
Hello, anybody know what is the correct Angle Dwell for Honda Fours??? Any people say 49º other 40/42º.......... Thank you in advance.
327
« on: July 24, 2013, 02:38:32 PM »
Two minutes of work and the engine Run as champion!!! 
328
« on: July 24, 2013, 11:18:29 AM »
My best tool!!tune-up my 400 and 550 Fours is very Easy with it!! Great accurate!!! 
329
« on: July 02, 2013, 03:45:34 PM »
Thank you guys, I had measure the block cylinder this Morning, the worst measure is 51,7mm, I think that I can follow with the stock cylinder and pistons for the moment(I do 4000km to year with this Bike) in the Future I can buy one Big bore kit and save money.....  Best Regards.
330
« on: June 29, 2013, 02:29:57 PM »
What about the Big bore kit from Cruzinimage?? I would like buy one Big Bore Kit (466cc), but I am afraid about the quality, If I buy one kit need I change other things on my Bike? Carbs?
Thank you in advance.
Pages: 1 ... 20 21 [22] 23 24
|
Show Posts
