This section allows you to view all posts made by this member. Note that you can only see posts made in areas you currently have access to.
Messages - Piki
Pages: 1 ... 21 22 [23] 24
331
« on: June 07, 2013, 01:27:36 PM »
400 Four sure!!!
Best Regards.
332
« on: June 07, 2013, 09:22:26 AM »
400 Four???
333
« on: June 06, 2013, 10:42:30 AM »
334
« on: June 06, 2013, 10:24:49 AM »
Hello, I am working in the carbs of my CB550K3(Pd46A) I have one "manual" that I found on Internet, I do not speak English and is very hard understand the manual, if you want I can send the manual link to you.
Best Regards and sorry for my English.
335
« on: June 05, 2013, 01:24:46 PM »
Ok guys, I will take off the cilynder block and remove the gasket and 4 o´rings.......
Thank you for your attention.
336
« on: June 05, 2013, 07:41:31 AM »
337
« on: June 04, 2013, 10:36:55 PM »
Hi Bitsa, I do not want to take off the block because the rings will change its position(they moves) and then them Will work in other position on the cylinder and this is not good. The engine has 55000 km and I have fit new rings( 53000km)
338
« on: June 04, 2013, 01:21:22 PM »
Thank you Bitsa, I understand you, but how can I fit the o´rings in its correct location without take off the cylinder block???  I can see a little from the o´ring out from its place, but I can not put it in the correct position because I do not have space to work and I do not want to take off the cylinder block..........
339
« on: June 04, 2013, 07:53:15 AM »
thanks ......... but what is its function? At the site where they are placed does not seem very important.
I have raised the head engine(I am working about one oil leak) and the cylinder block has risen also(the cylinder block was attached to the cylinder head),I looked below the cylinder block and seen the o´rings are out of place. I can not put it into place(I do not want take off the cylinder block because the engine has only 1200 milles with new o´rings from the last restauration), and I thought of leaving them as they are.............. What can I do?
Thank you very much and sorry for me English.
340
« on: June 03, 2013, 09:58:10 PM »
341
« on: May 27, 2013, 11:44:20 AM »
342
« on: May 27, 2013, 07:51:53 AM »
Hello, perhaps this is good for you:  "Used for splicing new wires on old coils. Joins two sections of plug wire together. Made from high impact plastic to provide a watertight connection".
343
« on: May 18, 2013, 12:41:56 PM »
Thank you very much Dan!!
344
« on: May 14, 2013, 04:45:58 PM »
Hello Again,
The RamAir Foam Just arrived at home and I have one dout, what position is the correct to install?? The Foam has ‘two colours“ one side black and grey the other side. Is indifferent the position?? The Grey side next the box air or the black??
Thank you in advance.
345
« on: May 13, 2013, 11:12:17 PM »
Uffff very expensive for me  I am looking for a "second hand" in good condition, Thanks UK Pete.
Pages: 1 ... 21 22 [23] 24
|
Show Posts
